Snap a grid of chalk lines on the floor to mark the dimensions of the sheets. Plan so that joints in the backerboard won't line up with joints in the subfloor. With the smooth side of a ¼-inch notched trowel, spread enough adhesive for one sheet. Ridge the adhesive with the notched side of the trowel.
While the adhesive is still wet, place a sheet of backerboard onto it. Leave a ¼-inch gap between the backerboard and the wall and a 1/8-inch gap between the backerboard sheets. Position the sheets so that you don't have four corners meeting.
After you've positioned each sheet, drive backerboard screws into it every 6-8 inches. Around the perimeter, position the screws at least 1/2 inch but no more than 2 inches from the edge.
With a margin trowel or the flat side of your notched trowel, fill the joints with adhesive, smoothing it so it extends about 1 1/2 inches on each side of the joint. The extra adhesive makes it easier to bed the tape.
Cover the adhesive-filled joints with 2-inch vinyl-coated fiberglass tape, pushing it firmly into the adhesive. You can cut the tape to length with the thin side of your trowel. When the tape is embedded, scrape off any excess adhesive from both sides.
Cover each length of tape with a thin layer of adhesive. Spread the adhesive with the flat side of your trowel, and feather the edges. You want the transition from board to board to be as smooth as possible.
