Water Heater Parts

Sort By:

Select 2 to 4 Items to Compare

Compare
  • • Ship to Home Free
  • • Ship to Store Free
  • • Ship to Home Free
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free
  • • Ship to Store Free
  • • Ship to Home Free
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free
  • • Ship to Home Free
  • • Ship to Store Free
  • • Ship to Home Free with $45 Order
  • • Ship to Store Free

Search Feedback

Did you find what you were looking for?

Tell us about your search experience. Your comments will help make our site better.

Thank you! You have successfully submitted feedback for this search.


Average rating for Water Heater Parts
(4.4 / 5)
2,435 Reviews
  1. 4 months ago
    great concept - but volume of alert may be a little low
    This is a low energy consumption device that takes a 9-volt battery and easily last over 6 months, perhaps even more than a year with a fresh 9-volt alkaline battery. I had been using a rechargeable one, and after 4 plus months, the battery appeared to have at least 75% power left. Thinking it may have not been working (I left it next to the water heater), I tested it and it did in fact work - the beeping is not as loud as a smoke detector, but if the house is quiet, I could probably hear it in ... read more the basement. If you paired this up with an internet-of-things sound detector, it would be a great combination. There is two metal contacts on the bottom. So if water that has spilled, hits both metal contacts, it will create a circuit making the alarm go off.
    Seeds Program Review
  2. 2 years ago
    works fine, just not terribly loud
    The alarm works fine - it triggers immediately if water contacts its base, and stops if you pick it up. It's just not terribly loud. I'll use it in the basement but doubt I'd hear it if I'm upstairs. The pitch is fairly high so your ability to hear it depends on your age and degree of high-frequency hearing loss. At 63 my hearing is still pretty good but this alarm probably seems louder to a younger person.
    Seeds Program Review
  3. 2 months ago
    Such a Simple, Useful Thing - Every Home Should Have at Least One
    If I had had this Honeywell water leak alarm when I moved in to my new-to-me home, it may have saved my wood floors from a disastrous water heater leak. Now that the water heater and floors are replaced, I put this in the water heater closet, confident it will alert me to any future leaks. It's such a simple thing to get, put in place and use - simply add a battery and put in place. Peace of mind for pennies.
    Seeds Program Review
  1. 1 year ago
    Great Value
    It used to be that it was very difficult to find an anode rod. Not any more... This one was easy to find, and a better value than I saw almost any where else. Thanks, HD!
  2. 6 months ago
    Good value, cheaper than a new water heater
    Old anode was just a 'pipe cap' - completely gone. And, it came out easier than expected. Problem is that I tried to buy two more of these anodes and HD was out of stock! So much for a good deal. this aluminum anode bent easily - necessary because the ceiling was closer than the anode rod length - and slid into the water heater after bending straight as it went in.
  3. 12 months ago
    Anode
    Good quality,easy to replace it is long need to bend and slowly straighten as entry into tank.
  1. 2 years ago
    Drain This
    The hard part was setting the heater onto the pan by myself. I picked up the water heater with a winch setting it on top of the pan that rested on a three inch high base. Everything was on a tarp which I used to drag the new heater into position. Removed the old hot water heater, pulled the tarp out and hooked up the plumbing. As I have no floor drain, I ran one inch PVC out the front of the house and used the same pipe for the AC drain.
  2. 1 year ago
    Something you install hoping it is never needed.
    We live in a condo built on a slab. If the WH tank leaks, there is a good chance some water will flow into the living space or the neighbor's unit and damage the flooring. (Other units have had this happen in recent months and we replaced our WH. The new energy standards for WH's will result in tanks to large to fit our cubby hole where the WH is.) In any event, this is your basic aluminum pan. Note- It is 22 inches across the bottom of the pan and larger still at the top. It required a little ... read more light hammer work to make it fit in our 21 1/4" space but it will do the job nicely if ever needed.
  3. 2 years ago
    Excellent drip/overflow pan!
    Well, other than this pan being required by code in most areas, works exactly as it should. It does come in two different sizes, so make sure you get the right size for your application. Not much else to say...
  1. 2 years ago
    Nice upgrade!
    This is an easy to install upgrade that makes a huge difference. Due to a very long run from the hot water heater to the master bath, we were waiting for what seemed like minutes for the hot water. Very wasteful. Installed this recirculator and set it up and voila, hot water is near instantaneous. Only complaint was the length of the 2 supply lines Watts includes with the kit--very short which made working under a bath sink with them difficult. For some folks, might be worth just buying longer ... read more braided supply lines to help with the install.
  2. 6 years ago
    watts recirculating pump
    This is the greatest thing ever. I admit I was skeptical, but there is nothing to fear. The cold water becoming hot has not been a problem, not even noticeable. I set the pump for most usage. i.e. 7:30am to ll:am then 3pm to 9:00pm. Works like a charm, always hot water easily available, no noticeable increase in electric either. Sorry I didn't get one a lot sooner. It has saved me 13 quarts of water every time I or the family takes a shower. (cold water before hot arrives in bath room) Easy to ... read more install. Runs quiet.
  3. 5 years ago
    Great addition to our house
    I'm a novice at home improvement but was able to install and start using this pump with relative ease. Our master bedroom is as far away from the hot water heater as possible. It normally took 1.5 minutes of cold water before we got hot. Now the hot is there in 5-10 seconds. The only downside is pipe clunking when the timer turns it off at night. I think i need to add one more of the special valves. I don't know what "branch plumbing" is but it was mentioned in the directions. My wife is quite happy with it.
  1. 7 months ago
    Seems to be a good product and solution.
    Product came quickly and the price with shipping was lower than most competing. I shopped around quite a bit online, read reviews etc. There is an inherent struggle to install one of these- no apparent way around it. We tipped it back, slid the tray in as far as possible, tipped forward, slid, adjusted. We were concerned the weight of the machine would break the tray edge but the product was resilient enough to withstand the weight of the washer on one rim edge while we tipped the machine down ... read more onto it. The tray was sleek enough to allow the machine to slide fairly easily into place after that. One then needs to re-level the machine after tipping it on the feet, a matter of tipping to and fro until the feet are level again. The whole process probably took us about a half hour. Overall so far satisfied with the purchase. It appears to be exactly what we needed and time will tell but it seems like a reasonably sturdy product that should last.
  2. 4 months ago
    good quality
    Good quality side holes are in the middle of the pan but you can make holes elsewhere if your careful..
  3. 3 months ago
    durable
    Durable but not really a good side mount do to only one position you can tap into.
  1. 2 years ago
    Totally solved the problem!
    There's not much to it. In most cases, if the pilot won't stay on, it's the thermocouple. With the help of some very good Youtube instructions, the replacement went very well. Just be careful with the components that don't need replacement, like the pilot gas tube and igniter.
  2. 1 month ago
    Perfect replacement for GE SG40T12TXK00 water heater
    Too soon to tell about longevity but this was a great replacement for the OEM POC thermocoupler on my GE SG40T12TXK00 water heater.
  3. 3 months ago
    Easy to install
    No hot water on a cold spring day. Quick trip to Depot and a small investment, took about 5 minutes to install. Hot water again!
  1. 1 year ago
    Buy these service valves
    If you are installing a tankless hot water heater buy these valves. They will save you money and make the whole installation and routine service easy and simple. The set comes with the pressure relief valve also and had a port of it. Every thing you need is in this set.
  2. 2 years ago
    Worth the extra expense !
    Definetly worth the extra expense.Will make things much easier when it comes to the annual maintenance of flushing and servicing of the unit.
  3. 2 years ago
    Feature rich. Excellent quality.
    The service valve kit is a very high quality set, which allows for a quick and easy way to isolate the heater system from the rest of the plumbing and simultaneously open the ports for system flushing/descaling; very handy during servicing of the unit. Installation is a breeze. Eliminated the need for pipe unions.
  1. 2 years ago
    Easy hot-water connect & no leaks
    The SharkBite 1/2 in. x 15 in. stainless steel push fit x FIP flexible water heater connector is a great new way to connect a water-heater or boiler to your home system. The female threaded ends screw onto the nipples from the tank with a bit of teflon tape to prevent sticking or corrosion and the SharkBite ends push right over cleaned and prepared pipes from the hot water inlet and cold water feed. When the water was turned back on, no leaks were detected from the new stainless steel mesh ... read more connectors and not even a droplet was released by the push-on ends. The push-on ends will require a special clip (sold separately) to remove. I recommend these SharkBite connectors for both do-it-yourself and professional plumbers.
  2. 2 months ago
    easy fix
    This item makes instillation very simple. It is a great idea instead of having to get a plumber
  3. 4 years ago
    This product will save you from hiring a plumber
    I love shark bite. They are the best thing since sliced bread. The is no need to solder, just cut your pipe to the correct length and push together. They are a bit pricey but a plumber is a lot more. That's if you can get one to do a small job. Thanks shark bite
  • 2016-06-24
  • bvseo_sps, prod_bvsp
  • cp_1
  • tr_24
  • loc_en_US, PRD
  • clientname_HomeDepot, pc_8, tc_8
  • bvseo_sdk, java_sdk, bvseo-2.3.0.0
  • CLOUD, getContent, 89ms
  • SPOTLIGHTS, CATEGORY