Free shipping

Installing a Tub Spout

 
 
Installing a Tub Spout
 
Replacing your tub spout is a simple home improvement project that requires only a few tools and materials, and is fairly easy to complete.
 

WHAT YOU NEED FOR THIS JOB:

TOOLS:

MATERIALS:


 

Step 1

Step 1: Disconnect the old spout First, disconnect the old spout. Check under the spout to see if there’s a setscrew. If so, loosen and slide it off the spout. If there’s no setscrew, use a pipe wrench to unscrew the spout from the threaded pipe. But be careful not to twist too tightly, because you can damage the spout nipple, especially if it’s made of copper. Liberally apply joint compound to the nipple thread
  

Step 2

Step 2: Install the new spout over the pipe Install the new spout. Slide the new spout over the pipe, make sure it’s snug to the wall, and tighten the screw. If it’s a threaded pipe, screw on the spout by hand. If it needs further tightening, put tape over the teeth of the water-pump pliers to prevent scratching, and tighten until the spout is snug.
  

Step 3

Step 3: Run silicone caulk around the spout Run silicone caulk around the spout, wiping off the excess. Make sure you allow the caulk to dry before using the new spout.