Rated 4.0 out of 5 by 13
Rated 4.0 out of 5.0 by DerekPooch Doing its job
My B&G pump (original I think) began a slow leak so I initially looked into replacing the guts of that device, but after finding this at Home Depot for around $75 there were virtually no cost savings, so I decided to go with this one. Easy install and you only need the gaskets that come with the device if you are replacing another unit
April 12, 2016
Rated 5.0 out of 5.0 by Delta The standard pump of the industry, have used TACO pumps for 50 years.
This pump was a complete pump that will fit many instances in my hot water system. TACO is the best because you can just replace the motor insert in most cases, not the whole pump. The "field" windings stay in the motor enclosure and the "pump - armature" are replaced separately with no wiring involved.
4 screws and you are done.
June 9, 2015
Rated 2.0 out of 5.0 by Michael333 Works well but only lasts one or two years. Quality has gone down with these.
Works well but only lasts one or two years. Quality has gone down with these. Also, HD doesn't sell the replacement cartridge. Wish they would since I have about 3 or 4 of these that are dead in the basement.
February 29, 2016
Rated 5.0 out of 5.0 by staceysdad Taco 007f5 - Easy Installation
After 18 years of use, the original Taco 007f5 circulator pump on our furnace quit. It resumed running when gently tapped. Fearing the worst, I picked up this replacement at Home Depot, but didn't immediately install it as it was so cold out, and I wanted to avoid problems during that time. Sure enough, 2 hours before the Superbowl the original pump quit. Fortunately, there were shuts offs leading into and out of the pump. With the breaker and valves turned off, 4 bolts and two wires later, I was back in business. There were even two new o-rings included. The only problem was that I had to take the new motor off of it's mounting and rotate is 180 degrees to fit my application. A you tube video showed this process, and I experimented on the old one first. Perfect fit and an easy job.
February 17, 2015
Rated 5.0 out of 5.0 by PappiG In The Middle of Winter
In the middle of winter my old 300lb 1/2 HP circulator burns out. I replace it with this Evco 1/25 hp ,water cooled unit. It was easy to install, purged the system and was up and running in no time! Price was also competitive. Friendly online pickup too.
April 7, 2015
Rated 5.0 out of 5.0 by BUCKSHOT THE BEST PUMP
I REPLACED TWO OF THEM IN 30 YEARS. THE ONLY THING IS YOU CAN'T BUY THE REPLACEMENT MOTOR YOU NEED TO PUT THE WHOLE PUMP ON
January 20, 2015
Rated 1.0 out of 5.0 by Disappointed Doesn't last long
Two years ago, I bought this pump as a replacement for a pump that ran for 17 years. It failed already.
It is not worth the cost.
November 3, 2014
Rated 5.0 out of 5.0 by NHEngineer Works well, quiet
The old one had run 15+ years(do not know any other history as I did not own the house), I replaced it with the same model and am up and running instantly. Hopefully this new one lasts as long as the same, older model! So far so good! It is actually a lot quieter than the old version, I had to place my hand on the housing to ensure it was running and it was. Very pleased.
February 2, 2013