Rated 1.8 out of 5 by 25
Rated 1.0 out of 5.0 by Tony Flapper design is faulty
Installed easily. However, after trying all adjustments and posible alignment issues the flapper does not permit a full flush. Put the old flapper on from the Fluidmast and worked perfectly the first flush. Ideally, I should remove the substandard Everbuilt, but as another poster stated earlier it is easier to just add a new $5 Fluidmaster flapper. Out of principal I may remove the Everbuilt (1000 308 432) and return. Definitely returnig the second one purchased for 2nd toilet. In short, The flapper in this fill valve needs to be recalled. Current product should be pulled from the shelf until situation rectified. Stop selling it HD.
October 12, 2016
Rated 1.0 out of 5.0 by Disatisfiedcustomer Leaks worse than original
I wish i read reviews before buying. What a complete waste of time and money. Same valve leaking
September 28, 2016
Rated 1.0 out of 5.0 by DIYERFM Pure Garbage
Leaks worse than ever, now I have to re-do it with an American Standard.....
October 13, 2016
Rated 2.0 out of 5.0 by RtnSA Works with a better flapper!
Bought this cause(old one)the top shaft that holds the inlet for the water was cracking with age. Water was leaking, water kept turning on and off. Now I had bigger problems, thought i was going to need a plumber. I messed with rubber flapper and noticed it did not seat right. Blue flapper is junk, go get a relacement-Flowmaster 2"universal flapper-5 dollars more but worth it. Old Standard American toilet#4078 fixed! PS. Make sure you get the parts kit(2-screws, toilet gasket) to re-set the tank to toilet.
September 3, 2016
Rated 1.0 out of 5.0 by Randy Leaks ridiculously after 6 months!
This flush valve worked briefly, now it leaks even though the valve seems to seat perfectly. I can't figure it out so I will have to replace it with ANY BRAND BUT THIS ONE. I wish I had read the reviews before I went shopping. If Home Depot would read their own reviews and get the junk off their shelves it would be better for them and for us. Good grief!
August 28, 2016
Rated 1.0 out of 5.0 by adrian00973 Replacement flush valve kit made leaking toilet worse!!
Product was very easy to install,.... (and just as easy to remove) because it made my leaking toilet issue worse. There is a defect between the valve and flapper assembly, they don't make a seal and toilet tank level constantly leaks through. I installed a Fluidmaster the second time and no problems as of yet. Home Depot should recall and discontinue this piece of junk to save their customers this waste of time and inconvenience. "DO NOT BUY THIS PRODUCT!"
August 9, 2016
Rated 1.0 out of 5.0 by Chuck77345 Flapper won't seal to flush valve
I should have read the other reviews before purchasing this product. The flapper will not seal to the flush valve, no matter what I try. I have had the tank on an off several times to determine what was happening. The leak is severe enough that the toilet won't even fill completely. I have successfully repaired many toilets in my life. This was the only flush valve offered at my Home Depot or I wouldn't have even tried it. Home Depot needs to heed these views and fix their product.
August 5, 2016
Rated 1.0 out of 5.0 by Brian Junk!
Had a leaking flapper on a ten year old toilet so decided to replace the entire flapper and seat/overflow assembly to avoid any issues with a worn seat. This was the only one HD had in stock so it's what I bought. Flapper leaked from the start. Really poor design that has a rubber seal mated to a plastic center piece. The rubber seal is warped and separating from the plastic which it just friction fits into. Total junk!
Since I had to pull the entire tank to install this I decided to just get a new universal flapper rather than pulling the entire tank again so I could return it. Well a universal flapper does not fit this overflow/seat assembly. So that was another wasted trip and another return I have to do.
Do not buy. You will be sorry.
July 15, 2016