Rated 3.9 out of 5 by 11
Rated 5.0 out of 5.0 by Treadstone I Don' Understand the Complaints!!!*****Perfect Fit***Good Quality
Bought this set to replace the shower valves and seats in our house built in 1978. Everything came in the package and was a direct replacement. Instructions were simple too. This is a DIY'ers dream project.
May 29, 2016
Rated 4.0 out of 5.0 by Duke5358 Did the Job.
The kit was much easier to install than I thought it would be. The instructions are very lacking, but the best thing to remember is "Do not install the spacers to hold the valve cover on". It will leak every time and cut the o-ring seal. Leave it off and use clear plumbers goop to hold the cover on. Other than that, the kit was a joy and no more leaking faucets.
July 19, 2016
Rated 4.0 out of 5.0 by Bill Sayco complete rebuild kit 3 handle valve tub/shower
Product was delivered quickly and was as advertised.
July 19, 2016
Rated 4.0 out of 5.0 by Patty Good buy!
Was easy to instill good quality, would buy again.
July 20, 2016
Rated 3.0 out of 5.0 by Fred valve tub/shower trim kit
one of the stems was bent and missing washers.
Had to go to local Home Depot to get a new one.
December 8, 2015
Rated 4.0 out of 5.0 by Bitsybit Faucets in Chrome
The faucets handles are nice, although I really wish they came in brushed chrome or nickel. However, as old as the plumbing is, I'm grateful we found them at all!
June 16, 2015
Rated 4.0 out of 5.0 by Cliff Perfect fit and appearance with a few quality flaws
Almost everything included to do the swap except no tool for removing and replacing the valve seats. Seats are included but I couldn't use them since I simply could not remove the old ones. I had to use a seat cutter to renew the old ones.
The plumbers socket is included to remove the stems but it is fairly soft and rounded out inside trying to get the diverter stem out. Also, there is a cross hole drilled in the socket to use a screwdriver or bar as a handle but the hole is drilled too far down on the socket so when a bar is inserted the socket will not reach far enough down to the hex of the lowest part of the stem. It hits the end of the stem about a quarter inch too high.
One of the handles didn't have the screw hole! The casting had a thick flash totally blocking the hole but was easy enough to drill out. Overall a geat kit but frustrating to not be able to use the included seats.
October 23, 2011
Rated 5.0 out of 5.0 by PlumberJohn I fits perfect and easy to install
It is a great way to repair and old Gopher bath facet with no tearing up the walls
February 4, 2014