Rated 3.7 out of 5 by 177
Rated 4.0 out of 5.0 by VegasAgent Looks fine, lightweight.
These look nice. Used them on his and hers closets, double doors. They are made from easily-scratched pressboard so make sure you paint them right away. I removed the hinges before painting. I saw some reviews said the door handles can spin. Well, make sure you drill the holes slightly smaller than the screw size--just like the instructions say, works fine. These operate very smoothly and easily.
May 27, 2013
Rated 4.0 out of 5.0 by Gary Fast. Easy. Looks and works great!
Good value. Easy install. Looks and works great! I'd use this door sgain.
July 1, 2014
Rated 5.0 out of 5.0 by DonF Great value
Great price and value. Easy to install, instructions easy to follow.
January 14, 2014
Rated 4.0 out of 5.0 by ldddd bifold closet doors
It will take a while before I know If I truly like these doors. I previously had metal doors with slat breathing wholes that were a horrible pain to clean and the doors rusted near the louvres. I am hopping thius door will live a long happy life in my home looking beautiful (as it does because I was able to paint it to match the trim with a paint that is cleanable with a rag and water). I believe this is going to be a great purchase. He had to add a header wall because to get a door the write width it was way to short unless I special ordered which would be way to expensive (but that was the builders fault not yours)
July 27, 2014
Rated 1.0 out of 5.0 by JCZ1 Jeld Wen Bi-Fold doors made of pressed cardboard
The surrounding core of these doors are made of pressed cardboard material. For a remodel, or new application the movement of the stationary hardware installed top and bottom of these doors gave some wear to the factory pre-drilled holes in this core. As a professional I would expect this to wear over time and need repaired. I had to cut one door bottom per new carpet height and it did not last and had to be benched for a sound 1 1/2 actual wood core replacement. Door is garbage. Would not use again. Shop for better quality.
April 10, 2015
Rated 3.0 out of 5.0 by Dave Some Installation Problems
Two installation issues:
1.) I constructed the finished opening to 81-1/2 inches on the Jen Weld installation information that the height clearance had to be 1-1/2 inches. The door height is listed as 80 inches in many places, actually it is 79 inches so I had to add a 5/4 board to the top of the opening.
2.) I had to adjust the position of the upper pivot and then I couldn't get it to stay where I wanted it. Either the track or the pivot bracket deforms and the locking screw can easily be over-tightened. After that, the pivot can't be locked in place. I have encountered many Jen Weld bifold doors over the years and the locking screw that anchors the upper pivot location is always a problem. I replaced the pivot locking screw with a 2 inch wood screw and drilled a pilot hole through the track. I think it will hold but I shouldn't have to MacGyver a brand new one.
September 25, 2016
Rated 4.0 out of 5.0 by Handy Easy to replace existing doors
I was replacing a 30-yr old set of 48" bi-fold pantry doors. I removed the old track and hardware and replaced with new. Everything fit perfectly. Once I hung the doors, it only took a few minutes to adjust the level. I did make the mistake of installing the hardware on one of the doors upside down. Be careful not to do this as it is difficult to remove the hardware from the doors once installed. I was able to remove the hardware and re-install correctly without any damage to the hardware or the door. The new doors look great!
September 6, 2016
Rated 5.0 out of 5.0 by Rdcurtis50 love these doors!!!
High quality and easy to paint.....love these doors!
September 20, 2016