Rated 3.8 out of 5 by 56
Rated 4.0 out of 5.0 by KMM1 Sink Strainer
It's a sink strainer. It does what a sink strainer is supposed to do.
May 3, 2016
Rated 5.0 out of 5.0 by Meco Great Bargin
This is just one of my recent purchases at The Home Depot. They were used on a new under the counter double sink. I also purchased a 36" Nutone under cabinet range hood that fitted nicely on our new Glacier Bay Cabinets (also bought at The Home Depot. I did all the instalation with the help of my wife (it was that easy to install). Now we are enjoying our kitchen (I do most of the cooking at home). Thank you Home Depot and your super qualified personal that helped us from the design stage to helpful tips on the final stages of our proyect. And yes even the floor is from The Home Depot and we installed it ourselves.
November 11, 2014
Rated 4.0 out of 5.0 by Bull Easy installation and good price.
Decent item for a good price. It was an easy install also.
September 2, 2014
Rated 1.0 out of 5.0 by Squatch Went through three of these
The locknut was too loose-fitting and kept slipping on the basket threads... exchanged it for a new one, and voila – same thing! One the third one, the basket tightened up properly, but the compression nut that secures the tailpipe kept cross-threading.
I finally ended up getting a Kohler, and had my sink up and running leak-free within five minutes.
October 10, 2015
Rated 5.0 out of 5.0 by airduncan Great product and easy to install
Buy the wrench to loosen the old one and also helps with proper fit on the new one.
January 28, 2014
Rated 3.0 out of 5.0 by Newbytattoo1977 Good replacement.
Product installs easily with minimal tools. Strainer stays in place well with the tab on the bottom. Not the greatest quality but it's ok.
January 14, 2014
Rated 5.0 out of 5.0 by Trisha Great product!
I needed these to replace the original ones that came with a farm sink I bought. They work perfectly.
January 29, 2014
Rated 1.0 out of 5.0 by HumanLabRat Threads to connect the tailpiece is flawed.
Glacier Bay sink strainer is not good. This sink strainer and most of the lower priced Glacier Bay sink strainers all have a big flaw. The threads that attach the tailpiece are very rounded as opposed to sharp and triangular. So, you unable to tighten the metal nut that connects the tailpiece tight enough to install it properly and leak proof. I found that the metal nut will thread on properly with no tailpiece, however, as soon as you add the tailpiece, it makes the threads decrease by about 3/16" which allows for very few threads holding it. When you tighten it, it will just slip off the threads.
The threads for connecting the sink strainer to the sink are fine. No problems installing that aspect of the sink strainer. Also, the sink strainer is all metal which is preferred construction.
You have to pay 20 bucks to get one that has sharp triangular threads that can hold the tailpiece. They used to have way better sink strainers than this around the same price point. They really need to cut the threads normal for the tailpiece. Pretty sure mine was not just a defective one because I have seen several models with the same flaw.
Surprised Home Depot allows this poor of quality item in their stores. Especially when so many contractors go there for parts. This part cost me 3 hours of installing, uninstalling, going back to the store, reinstalling a new more expensive one.
October 31, 2015