Rated 3.4 out of 5 by 5
Rated 1.0 out of 5.0 by Jasper Pulls Apart Easily and It Leaks Air
I recently purchased the Everbilt Dryer Duct Kit from Home Depot. that came with two of these kinds of elbows. It is a segmented device that you twist to get the angle the way you want. Those segments pull apart with just a little pull. Also, hot air leaks out between the segments reducing the airflow inside the venting tube reducing the power of the exhaust and also the distance you will be able to push the air and lent. The distance the hot air has to travel in my setup is about six feet vertically then out through the basement wall. You probably will have to apply tape around the leaks and the segments to keep it all together, but that might create a problem later on when you want to inspect the vent for lent build up. Lastly, my kit might have been tampered with at the store because one of the clamps to attach the elbows was new and the other was old and too small. A nuisance.
September 3, 2016
Rated 5.0 out of 5.0 by Mike Wish I bought this sooner
The dryer vent opening in the wall of the home I bought had a shredded pipe. This was the perfect solution to get the accordion, adjustable pipe onto it. It also adjusts to a variety of degrees with the moving parts. Well worth 4 bucks.
July 10, 2016
Rated 1.0 out of 5.0 by badbuy you get what you pay for
I purchased three of these to rerun a dryer vent, I went from a side by side to a stack W/D. Years ago I worked in HVAC doing installs and replacements. This is by far the worst 90 degree fitting I have used. The first one pulled apart simply adjusting it from the 90 degree position.
December 6, 2011
Rated 5.0 out of 5.0 by Rick HVAC duct work materials
I ordered numerous items including the 4" 90 degree HAV sheet metal elbows. They arrived professionally packed in just a few days and installed easily in my dust collection system in my shop.
May 28, 2006
Rated 5.0 out of 5.0 by John08970 Very Adjustable
Not much to say, but is very adjustable. Good for 90 deg, or 45 deg offsets.
November 24, 2011