Rated 3.7 out of 5��by 21
reviewers.
Rated 1.0 out of 5.0��by MrEd False Promise
None of the elbows that I purchased would adjust to become 90 degrees. In fact, they seem to be fused into anything but a 90 degree angle, barely moving.
The thin gauge metal construction bends when trying to turn the stuck segments of the elbow, making this fitting difficult or useless for the the intended application.
I returned them all after a frustrating effort at what should have been an easy job.
October 11, 2016
Rated 5.0 out of 5.0��by Lee Everything you need to complete ducting
DIY duct project in attic to vent the kitchen in addition to range hood. Everything I needed including a vent cap.
August 23, 2016
Rated 1.0 out of 5.0��by Jim poor quality hard to adjust
Elbow wouldn't adjust well after several minutes (like 30) of fighting I finally got it turned far enough to use it
June 14, 2016
Rated 1.0 out of 5.0��by LordManHammer Garbage
Cheap cheap cheap. Bought 4 of these to redo my friends ventilation system in his basement. They're very hard to adjust the angles and made of such thin, cheap material picture a slightly stronger pop can. Thats how flimsy these things are. I dropped one about 3 feet to the floor and it literally flew apart into 3 pieces! Took about an hour to get it back together. I would only buy these if there was no other choice.
November 25, 2015
Rated 5.0 out of 5.0��by LIGO Does the job
Household class duct elbow fitted as expected. will use again fro house duct.
November 27, 2015
Rated 5.0 out of 5.0��by CHIN WAS WHAT I NEEDED TO FIX MY AIR DUCTS.
REPLACED EASILY. WAS WHAT I NEEDED TO FIX MY DUCT VENTS.
November 4, 2015
Rated 5.0 out of 5.0��by Suzzet Excellent product!
Fits perfectly, shipped fast, and was not damaged. I was surprised on one of the shipping labels, it asks for UPS to inspect before delivery, on a 5.00 product I was amazed and happy, THANK YOU!
August 26, 2015
Rated 3.0 out of 5.0��by AAINSTALLER Worked but bent
It fit and did the job but it was a bit of a struggle getting it to slide around to change the angle since it was slightly bent somewhere. After messing with it for 5 minutes or so I got it to go.
March 25, 2015
- 2016-10-30
- bvseo-cps-pl-PRR
All
All
