Rated 4.4 out of 5 by 41
Rated 5.0 out of 5.0 by rick Great flexible duct
I needed a 6" flexible duct for a new bathroom vent I installed. I only needed about 3 feet, but had to buy 25 feet. It worked great.
June 28, 2016
Rated 5.0 out of 5.0 by Al Well made product - easy to use
Well made with heavy duty jacket. I would buy again.
June 1, 2016
Rated 4.0 out of 5.0 by GregC Flexible Duct R6 Silver Jacket
Good product and easy to cut (scissors and wire cutters). I took the advice from a previous customer and took the whole box down in to the crawl space before opening. Glad I did.
May 3, 2016
Rated 2.0 out of 5.0 by JakeB NOT 25 FEET as described.
Good stuff. Durable and does the job. Unfortunately, I needed 24'8" of this product. I figured 25' would have been sufficient. I came up almost 12 inches short. Heads up before you order.
March 4, 2016
Rated 5.0 out of 5.0 by barry Duct
Great product. Easily installed. Recommend this product.
March 16, 2016
Rated 5.0 out of 5.0 by Lee Very easy to work with.
I am 63 years old. I was able to work with this product an install it in a crawl space that I had only 3 feet height at the most ! I used the materials for installation that I bought at Home Depot to go with the flexable duct work . I redid all my duct work for my house !t took me longer the most young people would of taken but in the end my heating system works great !! I found everything I needed to do the job right at Home Depot ! By the way I am a women and following instructions found on google I saved myself a lot of money ! Women can do a lot themself using Home Depot & Google to save money.
December 22, 2015
Rated 5.0 out of 5.0 by Singlemom Exactly what I needed!
I decided to tackle the replacement of my entire duct system as the quote from the pro's was in excess of $3000, and going up to $4800 after April 1st because of the heat in FL. All of the bedrooms were fed with 6" duct, so this was my product. It was very durable, both the inner tube and outer cover, and able to withstand some tugging without ripping or tearing, yet easy to cut with a box cutter for the initial cut, household scissors, and a wire snip to cut the wire. I would recommend that you wait to open the box when you are up in the attic if possible as it springs out like the "can of snakes" once you open it. This also allows you to connect one end, but still keep the balance of the duct contained and easier to handle, and it is lightweight enough that it was not too heavy or cumbersome to navigate through the attic. Because I was doing it alone, I needed for it to be durable enough for me to properly stretch it so it works most efficiently, and it held up perfectly. My air flow has been greatly improved with this product, with the inner tube connected with both a nylon zip tie, taped well with foil tape, with added spray adhesive to ensure it stuck, and then the insulation pulled up tight, and same process with the outer layer. I just finished this project, so time will be the test, but I anticipate it will hold up as the quality seems to be good. The price was great and I was able to get this project done for a fraction of the cost of paying the pro's, providing my own sweat and blood!
April 14, 2015
Rated 5.0 out of 5.0 by muke easy duct work for diyer
could not be any easier to use and was very good quality
February 10, 2016