Rated 3.8 out of 5 by 8
Rated 4.0 out of 5.0 by Brant It's a duct!
As long as you're careful, you won't dent it or cut yourself. I recommend tucking one edge of the seam into the other an inch or so below the actual end of the pipe and then sliding it into place so the ends align. Makes it easier to snap together. For extra rigidity, you can always buy multiple shorter lengths and screw them together. Two 2 foot ducts are a bit more sturdy than a single 5 foot, but of course that may not fit depending on your project.
September 13, 2016
Rated 3.0 out of 5.0 by Dowhatpro Incomplete crimping
The crimping was not complete around the pipe adding difficulty to installation.
September 27, 2016
Rated 3.0 out of 5.0 by Champ a real good purchas
I am recovering from a house fire and needed to replace the the vent pipe with the Austin city building code officer can make remodeling very difficult in Austin.
April 5, 2016
Rated 4.0 out of 5.0 by Handyman meets expectations
It worked like it was designed. It snapped together just fine.
January 13, 2015
Rated 5.0 out of 5.0 by richy heat duct
Quality product that's made for heat duct work supply
November 11, 2014
Rated 5.0 out of 5.0 by Grampy excellent product
Easy assembly..snapped together 1st time..ends mated well
November 5, 2014
Rated 2.0 out of 5.0 by OldHouse Wouldn't purchase again...
Very thin steel. Dents very easy. Had difficulty snapping the seams together. The seams had inconsistent shape along the length, increasing the difficulty to work with. Next time I'll spend a little extra to get heavier gauge steel.
September 23, 2014
Rated 4.0 out of 5.0 by Mike Perfect for my project
I liked it had little or no dents, was in good shape for my hot air project.
January 24, 2014