0742366008190

Model 1207782

Internet #100507542

Store SKU #115470

6 in. x 75 ft. Select Window and Door Flashing Tape

  • Withstands damage from UV for up to 1 year of outdoor exposure
  • Consumers find it easy to work with and use
  • Performs well, stopping wind and water around window frame

Frequently Bought Together

Product Overview

Nashua Trusted Tapes get the job done right, the first time, every time. Protect your windows and doors from rough weather with the Nashua Select Premium Butyl Rubber Tape Flashing. When properly installed, this versatile tape can help seal against wind-driven rain and air infiltration and defend against mold, mildew and premature decay. One roll is typically enough material to flash three standard windows or two doors.

  • High performance premium butyl rubber adhesive stays sticky in cold weather (to 20 Degree F) and doesn't flow in hot weather (to 180 Degree F)
  • Compatible with most common sealants and caulking materials-no damaging chemical interactions
  • Low VOC (Volatile Organic Compounds) content
  • Helps to defend against mold, mildew and premature decay

Info & Guides

You will need Adobe® Acrobat® Reader to view PDF documents.  Download a free copy from the Adobe Web site.

Specifications

Dimensions

Details

Warranty / Certifications

More Products With These Features

Search

Customer Questions & Answers

14 Questions35 Answers

Customer Questions & Answers

6 in. x 75 ft. Select Window and Door Flashing Tape
6 in. x 75 ft. Select Window and Door Flashing Tape

Ask your questions. Share your answers.

 
 
Clear Search Term
 
 
Sort By:
 
6 answers

Do you use a primer with the tape prior to installing ?

This question is from 6 in. x 75 ft. Select Window and Door Flashing Tape
Asked by
John
August 16, 2013
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (6)

December 26, 2014
Answer: 
No primer is needed with this tape, just peel and stick.
+1point
1out of 1found this answer helpful.
Was this helpful?helpful1unhelpful0

Asked by
Indiana
Read all my Q&A
December 10, 2014
Answer: 
I put mine over new wood that I had to replace when I put in a new window. I did not use any primer as the surface of the wood was smooth and the tape is adhesive enough to stay down. I would recommend removing any debris prior to using and make sure the surface is smooth.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Northeast
Read all my Q&A
October 28, 2014
Answer: 
Primer is not needed but being a 100 year old house I did apply a wood hardener before installation.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Phoenix AZ
Read all my Q&A
August 21, 2014
Answer: 
No, we install the flashing directly to the sheeting and then install house wrap over the top.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Kansas City, Mo.
Read all my Q&A
July 7, 2014
Answer: 
No
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Franklin, MA
Read all my Q&A
September 5, 2013
Answer: 
The butyl rubber adhesive used on Nashua Select Flashing has been developed and proven to provide exceptional anchorage to many common building materials such as rigid PVC, plywood, aluminum, and steel without the use of a primer. Other materials such as OSB, concrete masonry blocks (CMU), and fiberglass-coated gypsum board can have textured or coated surfaces that reduce the initial adhesion. For these Read More
The butyl rubber adhesive used on Nashua Select Flashing has been developed and proven to provide exceptional anchorage to many common building materials such as rigid PVC, plywood, aluminum, and steel without the use of a primer. Other materials such as OSB, concrete masonry blocks (CMU), and fiberglass-coated gypsum board can have textured or coated surfaces that reduce the initial adhesion. For these building materials, a primer such as Nashua 357 Premium Web Spray Adhesive can be used to help provide the additional anchorage needed for an air- and water-tight bond. Read Less
+5points
5out of 5found this answer helpful.
Was this helpful?helpful5unhelpful0
 
5 answers

Is this flexible enough to put at the bottom of a window sill?

This question is from 6 in. x 75 ft. Select Window and Door Flashing Tape
Asked by
NJ
Read all my Q&A
October 14, 2013
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (5)

December 26, 2014
Answer: 
The tape is fairly flexible, and can be creased and bent if needed. Characteristics are similar to 15# felt building paper.
+2points
2out of 2found this answer helpful.
Was this helpful?helpful2unhelpful0

Asked by
Indiana
Read all my Q&A
December 10, 2014
Answer: 
It is very flexible and I would recommend it for the bottom of your sill. I was able to easily slide the tape behind the siding without removing anything. Very flexible for sealing all around doors and windows.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Phoenix AZ
Read all my Q&A
August 21, 2014
Answer: 
Yes, we use it for sills, cut it to fit tight to framing and then cut a small (band aid piece) to cover the cut.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Kansas City, Mo.
Read all my Q&A
July 7, 2014
Answer: 
Yes
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Franklin, MA
Read all my Q&A
Home Improvement Profile: Professional
October 14, 2013
Answer: 
Yes, Nashua Select Flash has an extremely pliable polyethylene backing making it ideal for both sill and jamb flashing.
User submitted photo
User submitted photo
+2points
2out of 2found this answer helpful.
Was this helpful?helpful2unhelpful0
 
4 answers

Does it matter what tempature it is when you use it ? And is the material you use it on does tempature effect the use of it?t

This question is from 6 in. x 75 ft. Select Window and Door Flashing Tape
Asked by
Oak Harbor, WA
Read all my Q&A
November 5, 2014
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (4)

Asked by
Kansas City, Mo
Read all my Q&A
Home Improvement Profile: DIYer
September 21, 2015
Answer: 
I would say that it needs to be above freezing. It is quite sticky.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

December 26, 2014
Answer: 
I installed a door in the summer (80-90 degrees) and a window recently (30-40 degrees) and both adhered right away to wood and vinyl with no problem. So far, neither has shown signs of losing adhesion. If worried about adhesion in cold weather, you could heat the tape with a hair dryer or heat gun.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Indiana
Read all my Q&A
December 10, 2014
Answer: 
I used it when it was about 35 degrees outside. It was not difficult to work with at that temp. I believe it would be easier to smooth out any bubbles if it were warmer out than that. I used mine on wood and I do not believe temp had any effect.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

November 7, 2014
Answer: 
Thank you for your question. Yes, installation temperature is an important factor that can impact bonding and overall performance. For best results surfaces should be clean and dry. The temperature of the material you're bonding to can have a slight impact - particularly cold conditions - which can lower the surface energy of the material. The butyl adhesive on Nashua Select Flashing tape will bond to Read More
Thank you for your question. Yes, installation temperature is an important factor that can impact bonding and overall performance. For best results surfaces should be clean and dry. The temperature of the material you're bonding to can have a slight impact - particularly cold conditions - which can lower the surface energy of the material. The butyl adhesive on Nashua Select Flashing tape will bond to surfaces in conditions as cold as 20F, but absolute best results are achieved at 40-80F. Read Less
+1point
1out of 1found this answer helpful.
Was this helpful?helpful1unhelpful0
 
4 answers

SO...EACH CASE IS 23.88 ?

This question is from 6 in. x 75 ft. Select Window and Door Flashing Tape
Asked by
ATEBALLMAKER
TACOMA,WASHINGTON
July 6, 2013
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers (4)

Asked by
Indiana
Read all my Q&A
December 10, 2014
Answer: 
I bought a single roll at my local Home Depot. I only needed as much to go around a new window I was installing.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Kansas City, Mo.
Read all my Q&A
July 7, 2014
Answer: 
No, price per roll.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0

Asked by
Read all my Q&A
September 24, 2013
Answer: 
One roll of 25' is $24, but it's worth the money. Great product.
-1point
0out of 1found this answer helpful.
Was this helpful?helpful0unhelpful1

Asked by
THD Customer Support
Kennesaw, Ga
July 8, 2013
Answer: 
Thank you for asking. This item is currently out of stock online and we are waiting to receive inventory from the manufacture. However, we do have alternative models if you are interested. For any other questions, please call us at HomeDepot.com Customer Service 800-430-3376.
-2points
0out of 2found this answer helpful.
Was this helpful?helpful0unhelpful2
2 »
  • 2016-08-25 T13:16:46.116-05:00
  • bvseo_lps, prod_bvqa, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasquestionsanswers
  • loc_en_US, sid_100507542, prod, sort_default
2 »
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 74ms
  • QUESTIONS, PRODUCT

Customer Reviews

Rated 4.1 out of 5 by 21 reviewers.
Rated 5.0 out of 5.0 by Great Product. Simply put, it is a great product for keeping your home rot free! March 16, 2016
Rated 5.0 out of 5.0 by Recommendation I'm really pleased with this product, it fit my need perfectly. February 11, 2016
Rated 4.0 out of 5.0 by Very easy to use This product was very easy to use and gives confidence of a water-proof barrier around my new window. I was able to easily slide the tape in behind the siding without having to remove anything. I would recommend this product for anyone who wants an extra layer of protection against the weather around windows or doors. December 10, 2014
Rated 5.0 out of 5.0 by Window Seal and Flash Tape The seal tape is very easy to work with and the protective plastic side comes off pretty easily. I like that because when you're working with it on a ladder, you don't have to fuss with it. The seal has a nice balance of flexibility and adhesion. I highly recommend this product. February 16, 2016
Rated 4.0 out of 5.0 by A Great Product I recently installed a patio door that I got from Home Depot. I used this flashing membrane to seal around the door frame. It doesn't stick to wood or drywall real well, just enough to temporarily hold itself in place. It will stick to itself very well, so you have to be careful while handling. The silicone I used to seal between the door and membrane stuck to the membrane very well. All in all, a great product, and I had some left over when I was done. July 7, 2014
Rated 5.0 out of 5.0 by Very good quality Did exactly what the manufacturer claims. Very good adhesion. September 29, 2015
Rated 4.0 out of 5.0 by water proofing a shower area I saw a few guys on the web using this flashing around a shower pan to add an extra waterproof layer under the concrete backer just at the base. I am a first time home renovator.. learning a lot as I go. I was told that this wasn't necessary, perhaps overkill. but I like the added reassurance that water will not be leaking out of our shower base. we had to gut our master bath after water damage was discovered on the subfloor. So I used this around the base and in corners and odd seams that could cause problems. Then used a 4 mil vapor barrier overlapping this flashing. The back is a little hard to peel, and be careful not to let it tack to itself as it is almost impossible to pull apart. This is thick and I'm glad I found this product! March 27, 2015
Rated 3.0 out of 5.0 by Watch what you stick it to It failed miserably at what I got it for originally. I was hoping to seal a doorway on my shed before I put the door in. It stuck to the framing, but not at all to the textured side of the OSB sheathing. Nothing I did would get it to stick. I ended up pealing it off. That being said, I tried it in another area where I was sealing the ventilation on the walls where the Tyvek already was. There it worked excellent! It stuck to the Tyvek just peachy and did what I was hoping it would do. So you have to use this in the right place. Now I am a DIYer and not a contractor, so perhaps a contractor would have known this limitation and used a different prodcut, but from reading the packaging there is nothing about this. It makes it sound like it will stick to most any building material. So I am faulting the product a bit on this, thus why there was 3 stars and not 1. So as long as you understand the limitations that it will only stick to smooth surfaces, plan accordingly or look elsewhere for another product. June 23, 2015
  • 2016-08-20 T10:11:25.805-05:00
  • bvseo_lps, prod_bvrr, vn_prr_5.6
  • cp-1, bvpage1
  • co_hasreviews, tv_21, tr_21
  • loc_en_US, sid_100507542, prod, sort_default
2 >>
  • bvseo_sdk, java_sdk, bvseo-3.1.1
  • CLOUD, getContent, 40ms
  • REVIEWS, PRODUCT