Rated 3.1 out of 5 by 15
Rated 4.0 out of 5.0 by BobN54 Work well
I don't understand the one star reviews. These are easy to install with a battery power drill or driver and a 1/4" socket, and they do not show. They are galvanized steel, not aluminum. They make for a strong gutter installation that is suitable for most regions. In a challenging region where the gutter may become full to the top with ice, I would probably choose a more elaborate bracket system. If you are concerned about the screw hole through the back of the gutter, that is easily taken care of with a dab of caulk.
September 16, 2016
Rated 1.0 out of 5.0 by RetiredTom bad purchase
Try to buy "L" brackets if possible. These are terrible to install!
August 16, 2016
Rated 5.0 out of 5.0 by Ajax Great Hanger
Installation was easy. Have your cordless drill with 1/4 socket and you are good to go. Used do to some spike nails were coming out and gutter was sagging a little. Made my gutter like new again and no more sagging. Product is made well. They did not bend on me.
April 2, 2016
Rated 3.0 out of 5.0 by gcw1313 These hangers have a minor problem
Easy to install but the center of my gutter sagged and the hanger came loose from the gutter. I have these every 18 inches. A little over kill as the literature I got when I purchased them was to place on 24 inch centers or attach to ends of rafters. I did not notice when they started sagging and the water damaged my fascia board and the eave covering. If you use these check they have not bent or disengaged from the gutter every time you clean the gutter spring and fall. These do not allow the gutter to sit against the fascia. You might try putting shim between the fascia and the gutter. This should stop the gutter from sagging. Good luck.
July 21, 2012
Rated 1.0 out of 5.0 by doitright Love this product keeps me working
Love when they use this product in this region. The snow and ice bend the heck out of the bracket at the screw head. I pull them out throw them away and install gutter screws walk away and have no more issues with bent up gutters. So people keep using them and keep me in business. Granted the screws don't look as clean but your gutters don't get damaged.
April 15, 2015
Rated 1.0 out of 5.0 by 2Handy Substandard Product
I purchased enough hangars to do the front proton of my house from another major supplier and they were a much better quality. I purchased these hangars for the rear of my house and could immediately tell the difference. These are low quality aluminum that bend easily and don't hang onto the front of the gutter very well. They also bend very easily when attaching to the gutter, and deform when torquing the screw into place. I have to pull down the one's I attached and return them. Very annoying.
January 1, 2015
Rated 1.0 out of 5.0 by WinterStinks Shear strength is terrible.
I installed every 24 inches and made sure they were at rafter points even though my fascia is a 2x8. After one snow the entire gutter collapsed. Every screw was sheared 3/16 past clamp area. I had the last gutter up for 20 years in every Ohio snow and freeze. These are junk, but you get what you pay for.
January 12, 2015
Rated 5.0 out of 5.0 by TheKingsHandyman Great Gutter hanger
I have been repairing many a house that needs the gutters to be rehung. I have used the large screws, which are much better than the original spikes. Now that I found these screw in brackets, they are all I use for the standard gutters. I can put them on the gutter before I raise them up and then set one end, get the proper down slop and set any of the others. They stay put, they are easy to screw in, and the are very strong. I highly recommend these for both new and repair installations that require gutter hangers. Great idea - now all I need is a bulk pac.
September 1, 2010