Rated 3.8 out of 5 by 36
Rated 3.0 out of 5.0 by AlexZ Economical and probably effective, but very unattractive
I'm glad I purchased only one or these to test out before taking the plunge on the whole house. It took a bit of time to figure out the clamps but i imagine it'd be a pretty easy installation once I got the hang of it. Then I climbed down off the ladder to look at it from the driveway of my one story rancher. The visual was very disappointing. I rarely get hung up on appearances and typically buy into the "it's function, not fashion" mentality. But not when it's this bad. Perhaps they'd be more concealed on a two story house that's above grade.
I read elsewhere that these guards aren't very effective against pine needles, but I only have deciduous trees in my yard. That's why the aesthetic issue is such a bummer because I found something that seems very inexpensive and effective
September 4, 2016
Rated 5.0 out of 5.0 by Erick Very easy installation
Installation was easy and straightforward. From a distance you can't even tell they're are guards on the gutters
July 27, 2016
Rated 2.0 out of 5.0 by averagejoe45321 Wont stay in place
The clips just don't work. They pop off constantly, have to be squeezed with pliers and pressed back into place, just to pop off again.
May 21, 2016
Rated 5.0 out of 5.0 by Deerfood easy and effective
Installed 150 feet of this product about 2 months ago, observed it during light and heavy rains. It works fine except where the high-roof downspout adds to the low-roof runoff; there I added a sheet metal diverter (see photos).
Installation was easy. No need to flatten them (the curve prevents them from curling), but I did install them under the shingles. Overlapped them about 1/2 inch but probably didn't need to. Finished in about 6 hours work, mostly on 28-ft ladder. Wonder how they work in snow and ice?
August 15, 2013
Rated 5.0 out of 5.0 by Guy Grill mesh
I actually used this as grille mesh for my Dodge Dakota. Looks great but I'll probably have to paint it. That's what plasti dip is for. It's very easy to manipulate with tin snips but be sure to wear gloves!
March 26, 2016
Rated 5.0 out of 5.0 by Mark The best gutter guard
I have had Amerimax 85280 Hinged Gutter Guards on my roof for 8 years. I had to re-attach them recently after putting on a new roof. The gutters are aluminum with too thick of an edge to clip the guards on. My previous roof had thin enough shingles that I just clipped the guards on the shingles. They had a tendency to blow up in a very high wind since the hinge was away from the wind, but otherwise were the best gutter guards I have seen. The new shingles were too thick to hold the guard clips; browsing the internet didn’t reveal any guard products that came close to the Amerimax – no matter how good the guard, something able to clog the gutter drain will eventually get in. The beauty of the Amerimax is that they flip up out of the way for easy cleaning (besides keeping most of the debris out in the first place).
After thinking it over, I decided keep my Amerimax guards and drill a hole in each hinge and screw the hinge to the gutter. I used an 11/64 cobalt drill bit (cobalt is necessary) to drill the hole and a set of needle nose pliers to hold the hinge. It took less than an hour to drill the hinges on 35 guards. I used a pistol grip electric screw driver and 6 x ½ metal screws to attach the guards. I used a Sharpee marker to mark where to drill, moved the hinge aside, drilled the screw in with the screw driver, then backed the screw out, put the hinge in place, and screwed the hinge down. See the attached photos.
With the hinged side on the leading edge of the gutter, the blow up issue seems to be gone. I am pleased to have the guards back in place.
August 19, 2013
Rated 1.0 out of 5.0 by DissatisfiedCustomer Useless
They are cheap and seem good value for money but they are badly designed, a pain to install and pretty useless. The clips do not hold the guards on to the gutter well. While I was trying to fit them, the slightest nudge caused the clips to ping off the gutter. The wire mesh is pretty flexible but this means it does not sit flush with the tiles. As I was installing them I noticed many places where there was a significant gap between the mesh and the roof tile, which will allow debris to get in to the gutter. I ended up trying to fold and bend the guards to wedge them under the tiles but that was not a good solution.
I also purchased the 25 pack. Biggest issue I had with these, and the reason I gave up, removed those I had installed, and went for a refund, was that the box of 25 guards (taped and staple sealed) had only 16 guards in it.
October 24, 2015
Rated 5.0 out of 5.0 by Hillbilly Great Product
Great gutter guards, easy to install. I did a 39 foot run of gutter in about an hour. I used some stainless screws in the front edge for extra strength. I over hung the ends about 3 inches cut off the corners then split it down the center then folded it over and put a screw it it, this covers the ends so nothing can blow in. I plan to use these on the rest of the house next summer. Much better than the plastic ones and American Made.
November 4, 2015