Rated 4.3 out of 5 by 26
Rated 4.0 out of 5.0 by Shellguana Fantastic product!
I have a room with wood floors, wainscotting on the walls and ceiling and chair rail. I had to stain it all and apply polyurithane. This product made it so easy! I applied both things using this and it went on beautifully! The only complaint is a small bit of fuzzies coming off but not enough to bother me. I have bought four of these.
May 13, 2016
Rated 1.0 out of 5.0 by Kgardner Terrible product
I used this to stain an old buffet I was re-doing. It applied the stain way to thickly and parts of the wool actually came off during the application process. Once the stain dried (way too darkly) I could see fuzzy bits of wool stuck to the outside. I ended up having to re-sand everything. I then used a rag to apply the stain instead of the lambs wool applicator- it looked 100 times better! I will never use an applicator like this again.
September 6, 2016
Rated 3.0 out of 5.0 by Dave Ok
Initially this applicator worked great. I was using it to stain two pine boards about 5ft long and 1/2 a foot wide. The applicator started to leave bunched up pieces of wool all over the stain which I had to manually remove, but by the end of the project there was a noticeable amount of tuffs all over my boards.
July 19, 2016
Rated 4.0 out of 5.0 by macool Very effecient, but can only use once
If you have a lot of lumber to stain this is does a far better and faster job than any brush.
August 10, 2016
Rated 5.0 out of 5.0 by Drparry1 Stain applicator
Worked much better then just a sponge or rag much more even coat. Very good product worth the extra $.
July 26, 2016
Rated 5.0 out of 5.0 by Gma amazing
this makes staining EASY
don't get that well if put together
August 2, 2016
Rated 5.0 out of 5.0 by joan Lambs wool applicator
Used it to apply polyurethane on wood floor. Worked great. Not messy. Helped to keep the job clean.
July 21, 2016
Rated 5.0 out of 5.0 by SM Best Product ever used for staining
I used this product to put an additional coat of stain/polyurethane on my wood table. I had used an expensive brush for the previous coats and had brush marks despite my thin careful applications. The top coat with the lamsbwool 5 in block went on beautifully! I was concerned about pieces of fiber in the finish so I read the directions on line and wet it slightly before hand. There are no fibers in this flawless finish!
June 5, 2016