Rated 4.6 out of 5 by 52
Rated 5.0 out of 5.0 by Harry Ariens Snowblower Cover
Home Depot will not stop sending me emails asking for my review of this product, so here it is. This cover is amazing! It fits over my snowblower as if it was made for that purpose. Its almost like its a fitted sheet, but better! I noticed that dust has settled on top of the cover, and I suspect that it has kept it from accumulating on the snowblower itself. The only problem is that it came with no instructions and I have been unable to find a power switch. Other than that I have been very satisfied.
July 12, 2016
Rated 5.0 out of 5.0 by Jimmy Harford County Snow Storm 1/24/2016
Outstanding performance. Easy to turn, start, operate, and the hand warmer was a big plus.
January 26, 2016
Rated 5.0 out of 5.0 by Mark Great Cover!!
The covert fit my snow blower perfectly and arrived very quickly!
June 21, 2016
Rated 3.0 out of 5.0 by AAAAAA Snow cover
The snow cover takes a little trial and error to get the fit right. This could be remedied with a simple diagram included with the product. It seems well put together with good materials, time will tell there.
March 1, 2016
Rated 5.0 out of 5.0 by dave Good quality cover
Protects my snowblower very well from the elements since I need to keep it outside during the winter
February 23, 2016
Rated 5.0 out of 5.0 by FloydT3 Fits like a glove
I have an older Craftsman 2-Stage Snowthrower with a 32" cut and a 20" depth and this cover fits perfectly.
Stays on nice and snug and is waterproof.
Care should be taken when covering your machine if it is hot though. This was a replacement because I didn't pay attention to the hor muffler and burned a hole in my old cover which was exactly the same as this cover.
With coupons, etc... this cover is well worth the $35 and will last a long while provided I don't screw it up again.
November 15, 2011
Rated 4.0 out of 5.0 by Insuranceman Keepin it dry
Fits like a glove. Snow blower is ready to go at a moments notice. Now we just need a little snow. :)
January 12, 2016
Rated 4.0 out of 5.0 by Jon solid machine
Since there isn't much snow here in NJ in August, I çàn only comment on the snow thrower assembly. The handle was very easy to snap into position and secure, but I must note that one side of the handle was slightly warped so that it didn't fit perfectly. Assembling the manual chute turning mechanism was somewhat tricky. When assembled according to instructions, the chute did not turn completely to the left. I had to adjust the assembly to get it to turn a full 180 degrees. With that fixed, I found that manually turning the chute with the handle control was a bit difficult. It did not turn easily. It may prove to be awkward to use when actually using the blower in snow.
August 18, 2015