The INOX20 railings are entirely made of AISI 304 stainless steel with a satin finish. They are characterized by round balusters joined together with 5 parallel tubes. The balusters include 5 feed-through tube holders and can be installed directly on the floor or to the side of the floor; they should be selected based on where they will be positioned. There are two baluster sizes: a short one (3 ft. 1-13/16 in.) for installation on the floor or a taller one (3 ft. 9-1/16 in.) for installation on the side. The baluster kits contain the hardware to join them to the handrail with the corresponding rivets. The balusters to be fastened on the floor also include plate covers. The handrail comes in 4 ft. 11-1/16 in. or 6 ft. 6-3/4 in. sections and can be joined directly to the balusters or a sleeve-shaped connector can be used. The individual handrail segments can be joined with 3 different types of joints. The handrail can be fastened to the wall with a choice of two types of support. The INOX20 railing is not a kit. You decide which pieces best suit your installation.
- Adjustable handrail joint
- Joint adjustable from 90 degrees to 180 degrees on the same plane
- Complete with 2 rivets
- Used with DA0820 or DA0720
- Important: Consult your local building inspector for specifics regarding compliance with the local building codes