Rated 2.1 out of 5 by 102
Rated 2.0 out of 5.0 by RG Weak power
Returned due to low power. Wouldn't drive staples into a pine 2x4... And pine is a soft wood!
July 9, 2016
Rated 1.0 out of 5.0 by chester Worst purchase ever
Bought this at my local store. The worst item ever I ever bought at Home Depot. It bends the 9/16" PowerShot brand brad nails, wasted my money on the tool and the brad nails. Will never buy again from HOME DEPOT.
June 5, 2016
Rated 1.0 out of 5.0 by Relaxrn Pine is too tough !
It wouldnot drive a staple all the way in to pine board. Gonna return it.
May 24, 2016
Rated 2.0 out of 5.0 by jason Not worth it
I purchased this to put up some plastic thinking it would speed up the process and save in hand cramps.
I found it is underpowered as others have said and going in to simple pine requires following up with a hammer.
That it likes to double tap, so the trigger is an art.
And the most annoying is it jams constantly. I've tried full strips of the recommended staples, half strips, small loads. Jamming is just its thing.
So I suggest looking for something better.
Even in a pinch this will add to your headache
April 9, 2016
Rated 1.0 out of 5.0 by Anya324 Piece of JUNK
Easily the worst staple gun ever. 1 out of every 5th staple stuck but still had to be set with a hammer. Shocked and disappointed that this 2 star item is what HomeDepot chooses the have in store. Like other customers, I thought it looked well made and appreciated the carrying case. What a let down!
May 13, 2016
Rated 1.0 out of 5.0 by TallT No staple feed spring
Would not feed staples. One shot, reload, one shot, reload.
April 22, 2016
Rated 1.0 out of 5.0 by Joe Don't buy, does not set staple to correct depth
Can't believe companies sell this stuff without a little R&D. Have to pound in the staples with a hammer. Its going back to the store.
April 3, 2016
Rated 1.0 out of 5.0 by Wiley Complete Junk, don't waste your money!
I bought this stapler to do some upholstery and thought it would save time and my hands. It doesn't drive the staples all the way in, not even close. I was stapling vinyl fabric to a thin piece of plywood, or should I say I was trying to. The staple would stick up out of the wood and fabric a good 1/16 of an inch and that was with 1/4 inch staples. There is no way to adjust for more or less power so you get what you get. Save your money and don't buy this stapler. I would take this back if I still had the receipt.
March 8, 2016