Rated 4.2 out of 5Â by 10
Rated 4 out of 5Â by FredN Good quality blade for the money
The blades are made in Italy by Freud. It is considered a B+ blade for everyday use. For knotscot, the reason the carbide is small because it is a thin kerf blade not the usual 1/8" full kerf. Thin kerf blades are recommended for saws that are 1 1/2 horse and under. I mill a lot of my own lumber and use these blades for that purpose. Not the blades I would use for my furniture projects.
A better than average than your $20-30 dollar blades.
August 10, 2014
Rated 4 out of 5Â by SliCruzer Great Deal!
Two blades for the price of one! Fast, clean cutting combo blades.
October 7, 2014
Rated 5 out of 5Â by bubba Great blades
Does the job well. I have used this on my table saw for trim work and it has worked well. No splintering on the edges and a smooth finish.
September 30, 2014
Rated 4 out of 5Â by GregG moderate price, good for occasional use.
worked well on my miter saw for non finish work. Moderate priced and sufficient for the project I had. Some chip out so would recommend a better blade for trim work.
September 28, 2014
Rated 4 out of 5Â by Tony They seem sharp and good
Used with my 10" sliding chop saw and works fine. I'm only using one blade now.
June 1, 2014