Rated 4.6 out of 5 by 40
Rated 5.0 out of 5.0 by madmax From Zero to Hero
Old and outdated, I had to remodel our shower and bathroom floor. In the effort to get it done fast, the square drain was cut too small by 3/8" and the toilet hole by 1/2". Mortar and porcelain set, I thought I had zero chance to fixing my mistake for cheap. Hence, shows up 4-1/2 IN. TURBO DIAMOND BLADE to the rescue. I can say I was skeptical but it did the job and it did it well! Used it on a Harbor Freight grinder with intervals of water from a tile sponge to keep the dust down. Says it can cut dry or wet but decided to prolong the blade life by keeping it wet. After I was done, the blade still looked like new. I can say this blade was my hero in saving me the headache of the more costly and/or labor intensive alternatives. Can't wait till I throw something else at it....Highly Recommend!
July 29, 2016
Rated 5.0 out of 5.0 by Pete Good blade for cutting concrete, wonderboard and rock veneer
I used this blade to cut concrete pavers, concrete rock veneer and cement board / Wonderboard and it works great.
August 16, 2016
Rated 5.0 out of 5.0 by eromero Cuts through stucco
Had a project to install a dog door through a stucco exterior wall. This blade cut perfectly without chipping off stucco. I got a nice clean cut.
August 23, 2016
Rated 5.0 out of 5.0 by Damaged1 Easy to use, easy to make large gouges in concrete
This will remove concrete and anything on top of it. Had some uneven areas where epoxy wasn't removed with a diamond grinder and this cleaned up those spots with ease. With good control you can create nicely leveled surfaces, but you can just as easily create large gouges.
July 26, 2016
Rated 4.0 out of 5.0 by Tom Hardi backer cutter
Fantastic for cutting this stuff. Dont know about other materials yet.
July 19, 2016
Rated 5.0 out of 5.0 by Whitey Cuts stucco like butter!
I needed to cut the stucco for my Bull Terrier's dog door. It literally cut the stucco and the metal mesh like butter. I have used a sawzall and a masonry blade to do it before and it was a nightmare.
June 16, 2016
Rated 5.0 out of 5.0 by judgeshawn should have bought this first
After spending 10 bucks on several of the cheaper blades and blowing through them, i got this one for about 10 bucks and it's like a hot knife through butter. Outlasted the others 100 fold.
June 21, 2016
Rated 4.0 out of 5.0 by MacEwen Used on hard ceramics - worked well great price
These blades were a great value. We used them to cut ceramics with a wet saw. That worked as well as more expensive blades. Very happy with these. They are priced right!.
June 21, 2016