Rated 4.0 out of 5 by 73
Rated 1.0 out of 5.0 by Humbucker Very Poor Saw Blade
I bought this saw blade for a project making a couple new workbenches for my shop. I wanted to make the bench tops out of two layers, a layer of 3/4 plywood topped by a sheet of 3/4 melamine. I've made benches this way before and like the result, but ripping sheets of plywood and melamine in a tablesaw can be awkward and a little dangerous. This time I thought I would rip the sheets with my circular saw to make things easier. Straight out of the package I could see burrs on the teeth of the blade, but I gave it a run anyway. This saw blade barely made it through the 3/4 plywood. As for the melamine, after about a foot into the sheet the blade overheated and warped. My cut went from straight and smooth to jagged. It may be ok for 1/4 ply or plastic sheeting, but it totally chokes on 3/4 inch sheet goods.
November 8, 2015
Rated 5.0 out of 5.0 by AHT Good blade
This was a good blade for my saw and I got clean cuts using it.
September 29, 2015
Rated 1.0 out of 5.0 by Adam Don't waste your money
After 8 cuts of 48" on 3/4 plywood the blade was dull. I guess I got what I paid for. Spend a few extra dollars and get a blade that will last.
September 4, 2015
Rated 4.0 out of 5.0 by handyman Nice work cutting off doors
Used this blade to cut off some doors after having new carpet installed. Along with a jig to keep my line straight it did a fantastic job without splintering the face of the door.
August 18, 2015
Rated 1.0 out of 5.0 by RegularCustomer Tooth Worn Off After 5 minutes of Cutting
Bought a two blade package from Home Depot. After 5 minutes of cutting some laminated floor, the tooth totally worn off the blade. The second blade worn off in 5 minutes too and generates a lot of smoke while sawing. I would buy a more expensive and better quality blade next time.
August 4, 2015
Rated 5.0 out of 5.0 by deadbug best saw blade
It worked great and was really needed. The last blade was so bad I thought the miter saw was broken, it was just the blade.
July 28, 2015
Rated 5.0 out of 5.0 by Rusty Blade for cutting Suntuf Panels
I used this blade to cut Suntuf corrugated panels. It worked well and did not split the panels.
August 26, 2014
Rated 4.0 out of 5.0 by LOOKINGOOD WORKED PRETTY WELL. A LITTLE SLUGGISH ON 3/4 PLYWOOD, BUT STILL CUT WELL!!
USED ON 3/4 PLYWOOD AND CUT QUITE WELL. HAD TO CUT FAIRLY SLOW, BUT DID THE JOB:)
June 30, 2015