Rated 4.4 out of 5 by 58
Rated 5.0 out of 5.0 by Dudecon Take it slow and it lasts for days
Cut a dozen yards of both brand new and thirty year old concrete. Cuts well, both wet and dry, and no noticeable blade degredation with cuts at about 3/4" deep and 1 yard per minute with frequent stops for cooling. If you push it too fast you'll smell the steel burning, but take it slow and this blade will last you for a good long while.
June 24, 2016
Rated 3.0 out of 5.0 by Notyourshill Not sure
I put this on a standard compound bevel sliding chop saw meant for wood working... And then started cutting concrete garden blocks... It cut the first few just fine, but cut less effectively shortly thereafter... I don't have the experience to say why this was. It could'a been me or something I did or didn't do right... Blade wear was minimal but I only made a couple dozen cuts... Yet the last ten were hard... I don't see how it could have been the chop saw's fault. Who cares what power head is spinning the blade. I'll have to use it again eventually, but if it disappoints me off one more time, I will find out why from a real masonry man..
September 6, 2016
Rated 5.0 out of 5.0 by Charles really did the job
I was helping my son put Bluestone treads on his old concrete steps. Used this blade in an old circular saw to cut about 20 cuts through the stone, 1.5 inches thick, dry and it held up very well. The price was so good, if it just wore out on this one job I'd be happy, but still cuts. Not sure why but I had to take the diamond shaped arbor from an old blade to get it to tighten in my saw. Nice tool, a 15 minute trip to HD and back home got me up and running to finish when my first HF wore out.
September 16, 2016
Rated 4.0 out of 5.0 by Don2Earth For cutting Hardie board
Bought this blade for 20 bucks as opposed to the diablo Hardie board blade for 55
August 23, 2016
Rated 5.0 out of 5.0 by MJA Exactly what I needed...
I needed a blade that would fit my Skill saw and would help me make custom cuts in old used red brick. This blade did the trick. I found that it works best by slowly cutting a 1/4" deep curf on both sides of the brick (or around all 4 surfaces if I needed to make a "thinner" brick) then striking with a masonry chisel.
August 23, 2016
Rated 5.0 out of 5.0 by THEWULF GREAT BLADE
GREAT CONCETE SAW BLADE FOR THE PRICE, I LIKE THE KERF STYLE
August 2, 2016
Rated 3.0 out of 5.0 by paw Red Bricks
I used this blade in a tile saw, wet cutting standard red bricks. The thickness of the bricks, 2 1/4" maxxed out the saw. I had a big project and cut a lot of bricks, the blade lasted 2 days and did NOT cut like butter or like cutting wood as others stated when cutting different materials. It worked OK but struggled slightly. I bought a similar blade the next day, a Makita at twice the price, $32. It lasted more than a week and still works OK when cutting softer bricks.
Both blades performed equally well but not spectacular. This blade cuts just as well as the more expensive blade but didn't last as long. If you have a small project buy this blade, a bigger project, buy the more expensive Makita.
July 16, 2016
Rated 4.0 out of 5.0 by homeimprovementlover1 good price better quality
After I have done the 2nd bath room , it is still smooth sharp cut. Properly it is still good for the 3rd one
August 9, 2016