Rated 3.1 out of 5 by 46
Rated 1.0 out of 5.0 by ST Don't waste your time and money with this rubbish
Purchased two of these kits for our two-car garage after the Behr representative at the store talked us into it. I had read poor reviews about this product and was going to buy a different concrete paint, but the guy talked me into it and that's my fault. Followed all instructions and applied the paint to the concrete floor. It looked great and it was easy to apply, dried fast. Instructions said not to walk/put anything in the garage for 3 days. Did that. We had some paint left over and we used it on a concrete walkway (covered area). In less than a week, the paint is already peeling off. What a disappointment. I'm going to have to purchase a sealer before the whole thing comes off. If the paint had stuck, it would be a good product.
October 24, 2012
Rated 2.0 out of 5.0 by Brian Careful with this one!
We purchased two of these, in the Tan color. The labels were slightly different, but the color code was the same: 955. However, the product inside was VERY different. One came out ok, the other, a disaster requiring a redo of the whole job.
In the good one, the paint in the container contains the tan colorant, ie, the paint is tan. In the bad one, the paint was white, and the colorant was actually in the epoxy can. The colorant had hardened and I had to dig it out of the can. It took a good 25-30 min of stirring to mix it. It came out a noticeably different color and sheen. But the worst part, it remains water soluble even 3 weeks after application. If it gets wet, it softens and comes right off! Totally Defective Product! So make sure you check the color of the paint inside the container - if it's white, DON"T BUY IT!!!
For both containers the coverage was less than the label stated (which is why we had to buy a second one).
May 24, 2014
Rated 4.0 out of 5.0 by TrapperJ Turned out mostly looking good
This product had me completely sold after I did part of my garage first. When I went to do the second half, for some reason part of it dried darker than the rest. It was the trim work and the whole edge that I put on the floor first. I stirred it for the full 5 minutes before starting so I'm not sure what else could have happened. I don't want to spend another $80 to fix it, so I'm probably just going to live with it for now. Overall it covered well, went on fast, and it really made a difference in my garage.
May 27, 2013
Rated 4.0 out of 5.0 by Oc Good quality for the price.
Note I would suggest you buy an additional bag of the color flake.
September 24, 2015
Rated 4.0 out of 5.0 by BobinVA Almost got it right
I purchased the Silver Gray 2-Part Epoxy Garage Floor Coating Kit for a 13' x 16' basement floor that I intend to use as a shop. See picture 1. The kit performed as advertized on this fairly rough 208 sqft floor, with a bit left over. See picture 2. I was concerned about coverage, because the box said 250 sqft, yet the included instructions said 200-250 sqft. I brushed the edges and rolled the floor in 3' rows. I was concerned that the not-so-wet-edge of the mating rows would be visible, but they dried evenly and you can't notice them. As I completed each row, I dispersed the flakes, as instructed. Unfortunately the flakes, as you might expect, just sit on top of the epoxy. See picture 3. They are not assimilated, and as the floor dries, some of the flakes - flake off. I solved the problem with the flakes by purchasing a Rust-Oleum EpoxyShield Clear High-Gloss Premium Clear Floor Coating Kit. Behr doesn't have a clear coat epoxy and I didn't want to use an their acrylic sealer. That is why I had to go with Rustoleum. There was enough epoxy in this kit to apply a single heavy coat. See picture 4. This top clear coat really made the floor come out like I expected and the flakes are well assimilated. See picture 5. Good luck on your floor.
March 24, 2014
Rated 1.0 out of 5.0 by mrh3090 Behr 2 Part Epoxy
I have used this product a couple times before with limited problems with the product. It has been inconsistant with getting the same results or each can is a little different. We followed the instructions to the letter. Our customer on this last job with this product called me and told me the floor was coming up and not just under the tires but all over. I will not use this product again and will not accept work with the Behr products. I now have to go through the warranty paperwork to prove it was a bad product and in order to get refunds on products we used and new product to redo. Bad product makes my business look bad too.
October 1, 2009
Rated 5.0 out of 5.0 by nathang great product that secured me 3 more jobs
Great product easy to use and a professional finish
August 3, 2015
Rated 2.0 out of 5.0 by RonSc BEHR 2-part epoxy floor Paint SKU# 102364
Pro's - good color selection, liked the additional color selections as I did not want to use the flake chips ( try to find a small screw or nail accidently dropped on a rough multicolor surface), adheres well on a properly prepared surface.
Cons - This water based coating is very thin, approx 2 mills in comparison to a real epoxy finish that is 9 to 16 mills. it does not fill any rough areas in the concrete (used a pressure washer to prep the surface which ate away the smooth finish in problem areas). final appearance same as a thin stain. floor chips easily since the coating is so thin.
will now have to purchase a real epoxy clear seal to finish the floor, so my cost just doubled.
April 12, 2009