Rated 2.2 out of 5 by 6
Rated 5.0 out of 5.0 by BadBob If you don't know how to wire solder, then don't use
Personally, I think the solder is fine. If you are having trouble with the solder balling up, then you have cooked the rosin out of the solder and the result is solder that will not flow. It's also possible the wire is contaminated by twisting the end of your wire with your fingers after stripping it. I had no trouble at all to get the solder to flow with stripped clean wire with prepped wire ends with a small amount of solder before joining the two pieces using a clean, prepped butane soldering pen. If you over heat the solder and the wire you will not get good results with this product.
June 28, 2016
Rated 4.0 out of 5.0 by jdhotrod20 nothing wrong with this solder
I used this to fix my 50 inch plasma TV, I am of beginner experience level at soldering, I had no trouble what so ever, I don't know why everyone else doesn't like this product worked just fine
December 23, 2015
Rated 1.0 out of 5.0 by Grusselgrosser I thought it was me, but now I see it isn't
Refuses to flow, solder that I got off of Ebay free with a $10 iron was easier to use than this. Absolute garbage.
December 22, 2015
Rated 1.0 out of 5.0 by Bloom Doesn't work...
Worst solder I've ever used in 20 years. Doesn't flow. Don't buy it!! It doesn't work!!
July 11, 2015
Rated 1.0 out of 5.0 by ken7 Poor Rosin Core Solder
Like the last review this solder does not flow, had to use flux to make it flow, little or no rosin in this product.
May 2, 2015
Rated 1.0 out of 5.0 by Gareth Worst Solder I Have Ever Used
This solder doesn't flow or wick into joints or wires as it should. It's as if it has not enough or no flux in the core. I am trained in Soldering and I know how solder should perform and this stuff is just plain poor. I wouldn't recommend using it under any circumstances.
February 26, 2015