Rated 4.9 out of 5 by 28
Rated 5.0 out of 5.0 by Rass3361 Great addition any MAPP or Propane system.
This hose extension is great to allow you to hold the torch at any angle and allows you to get into those tight locations without the tank getting in the way.
June 28, 2016
Rated 5.0 out of 5.0 by Bodyshoped The ticket
If you need to get into confined spaces with your torch, this could be the ticket. Works for me.
June 14, 2016
Rated 5.0 out of 5.0 by Arizonadude Did the trick
I used this to sweat some copper fittings for my sprinkler system. Previously I had tried to just use a propane burner attached directly to a small propane cylinder, and that did not give me enough maneuvering room since the fittings were close to the ground and next to the wall, plus if you hold it upside down the flame goes out. This unit solved the problem and made sweating the joints a breeze. Wished I had purchased it years ago, would have made some of my occassional fixit plumbing jobs around the house easier.
April 12, 2016
Rated 5.0 out of 5.0 by Crod Universal torch extention hose
Great item to have on area were the torch don't fit to weld a unit.
April 19, 2016
Rated 5.0 out of 5.0 by TijerasGuy If you need the flame to point down, you'll need this hose.
I am using Latex-ite PLI-STIX permanent asphalt crack filler to patch cracks in my asphalt driveway. I tried using a propane torch pointing downward- the flame kept going out. I read the directions for use and found out that it’s also risky to use a torch that way because of possible flare-ups. A propane torch is intended to be used with the tank standing upright. That makes sense, because the gaseous propane needs to come out of the opening at the top. Propane inside the cylinder is in a liquid form. Laying the cylinder on its side or turning it upside down caused the liquid to block the opening and, in my case, the flame kept going out.
I bought a Benzomatic WH0159 Universal Torch Extension Hose and a Benzomatic WT2301 Self-Igniting Basic Torch Head. With the hose connected to the tank and the Self-igniting head connected to the hose, the tank itself is upright in my tool carrier, and the job got a whole lot easier.
April 11, 2016
Rated 5.0 out of 5.0 by Verified Reviewer Fantastic Accessory
I was using a Benzomatic propane tank to melt a driveway crack filler but experienced flare ups when the tank was held on the slide. I ran back to the store to pick the extensions hose (which I should have done in the first place) and it solved my problems.
It come with a hook which is a nice feature for hanging the bottle and I found maneuvering and using the hose was a lot easier than waving the tank around itself. I highly recommend the torch extension hose to anyone who will be using the propane tank.
August 8, 2015
Rated 5.0 out of 5.0 by snhvac3 this is a life saver and will cut down on time to complete most tasks you have to do around your home or jobsite I suggest you purchase the TS3000sk
again I suggest you purchase the TS3000sk some flux etc. and your ready to go ! could of used this before I got my acetylene torch setup....but I use this for jobs where I need to go up a ladder like above ceilings... its light , easy to carry and is worth its low cost compared to a bottle with tip only which is great but if you need the versatility in tight spots this is your solution...Can't recommend this enough for the beginner to pro. With use the hose gets more limber or flexible like most hose bought from a package...
January 16, 2016
Rated 3.0 out of 5.0 by Jackimon Need better hose
This extension is a must if you need to do any welding in tight area. However, I wish the hose is made of soft rubber. It can be cut open easily. I did with my utility knife when I tried to open the package!!!
January 12, 2016