Rated 4.4 out of 5 by 9
Rated 3.0 out of 5.0 by Casual Dont use it in "Hammer" mode
Used the adapter chuck in my drill on hammer mode inorder to use none SDS bits ..... it broke after the 14th 1/2" hole drilled ....... i got another but i wont be using it in the hammer mode
September 23, 2015
Rated 5.0 out of 5.0 by Rob A nice addition to my tool set
This chuck works great and appears to be of good quality. With it I can turn standard bits with my rotary hammer, thereby adding versatility.
August 31, 2015
Rated 4.0 out of 5.0 by MGVcms Replacement chuck
This is the third one I have purchased to use in my Bosch Bulldog hammerdrill. Since the hammerdrill has an SDS chuck it is not possible to use regular drill bits without being SDS design. This chuck comes equipped with an SDS chuckable end and in turn uses a Jacobs chuck which will take regular drill bits. They are not without their faults however, since I have broken two over the years prior to this one, but it is to my knowledge the only manufactured one available that allows the ability to use regular non-SDS bits so I have no other choice if I want to use them in this drill.
August 24, 2011
Rated 5.0 out of 5.0 by Andy The right tool for my needs.
The Adapter Chuck made my new hammer drill the right tool to drill throw landscaping tie. I only wished the store on this item in stock. I had to put off project until chuck came in. The most helpful thing was the tech in store to help me pick out the tool I need for the job.
September 24, 2013
Rated 5.0 out of 5.0 by ToolGuy The adapter lets you use your collection of standard drill bits instead of buying new SDS.
Great product! The adapter lets you use your collection of standard drill bits instead of buying new SDS bits; saves you money. Easy to use and efficient... takes little additional time to install adapter chuck and standard bit compared to SDS bit.
January 8, 2013
Rated 5.0 out of 5.0 by elenalor It works!
Can save you a lot of money using regular drill bits with your SDS. Prompt shipping, return label included though not needed: I'm keeping it and buying more for my installers
March 19, 2013
Rated 4.0 out of 5.0 by Doug Arbor bent
Used this for a few years and it worked great - although the built-in depth guage does not work with it when the chuck is installed because the chuck extends too far. Also, after a few years of use, the arbor bent. Now I am replacing it for another 40 bucks.
September 12, 2011
Rated 4.0 out of 5.0 by PhillipJ Only last for a year of constant use.
Best tool for SDS Adapter but must keep dust free and lubricated for smooth operation.
December 18, 2012