Rated 4.1 out of 5 by 9
Rated 5.0 out of 5.0 by SteveC Great Value For 6.5 Watt LED Bulbs!
We are now using Home Depot as our sole source for LED bulbs.
September 27, 2016
Rated 4.0 out of 5.0 by Steveo Why you need to buy a pack....
I had a project needing 50 - 100 Tapcon concrete anchors in concrete block walls. This bit worked well and I did not need the hammer setting on my drill except a couple times. After about 40 holes, the Tapcon screws started binding and would not go all the way in. Hmmmm. The bit width had worn down past the screw specs. So,I tossed the first bit and grabbed another to finish the job. Bit breakage was not an issue but wear was. Guess that is why I bought a 5-pack.
October 18, 2016
Rated 4.0 out of 5.0 by Chris Good bit
used these to drill holes into a ceramic tile shower surround. worked well as tile is hard on bits. needs to be keep cooled with water. was good for 3 holes before it stopped cutting.
June 14, 2016
Rated 3.0 out of 5.0 by Brian155 Bosch masonary
Well the bit is so so. I like the shorter bits because the longerones tend to bend when alot of pressureis applied. Also theydont tend to last very long, have to constantly quench in water. I was drilling into tile.
February 16, 2016
Rated 5.0 out of 5.0 by carpenterguy Excellent concrete drills.
These bits work as intended. But if you hit steel it's all over.
December 23, 2015
Rated 4.0 out of 5.0 by JH Good Product
They stood up better than the Tapcom bits I was using before I tried these.
June 23, 2015
Rated 5.0 out of 5.0 by Customer Worked in Novabrik
I needed some bits to drill mounting holes in Novabrik ( a concrete based siding product that mimics brick). These bits did the job in a standard electric drill. It would have been faster in a hammer drill, but didn't want to break the bricks! They punched holes in the brick quickly, only slowing down if a large chunk of aggregate was encountered.
October 29, 2014
Rated 4.0 out of 5.0 by Hugo5 Nice product
Drilled a half dozen holes through stucco and cyinder block with the first bit and all is went well.
December 17, 2014