Rated 4.7 out of 5 by 7
Rated 3.0 out of 5.0 by Yorkie Better to score and break with a knif than to use the saw.
I thought the saw with this blade, specially made for cutting Plexiglas, would be ideal. Turns out it was easier to score and break the glass using a very sharp box cutter. The saw caused too much motion making the glass splinter. Guess a lot more clamps might have helped.
September 13, 2016
Rated 5.0 out of 5.0 by mike Plex Glass Blades
The price is good and quality is excellent so for me it's best to have on hand when needed...
September 8, 2016
Rated 5.0 out of 5.0 by Duke Extraordinarily good saw blade
I made a windbreak for my wife's Miata from a 1/4" thick sheet of Lexan. This was my first time cutting sheet plastic and had planned to put a trim on the edges to hide expected rough, imperfect cuts. However, when completed, I was impressed by the exceptionally fine finish of the edges and found it unnecessary to sand or hide them. I used only one blade to cut straight lines, quarter radiuses and diminishing curves -- the latter two cuts were free-hand! The Bosch blade gave me good cutting control: I used the jigsaw's high speed setting without causing the Lexan to melt. My first-timer's confidence soared. An automotive hardware specialist saw the finished edges and said he thought the windbreak was made from glass - until he touched it. These blades are precision tools and can only imagine what they do in more capable hands.
October 23, 2015
Rated 5.0 out of 5.0 by ou812 Very good for plastics
I bought these for making curved cuts in acrylic and polycarbonate sheets. They work well, once you adjust your saw speed and move at a constant pace. I would like to note that this works best for acrylic which is at least 1/8" in diameter. When I tried to cut a piece of 1/16" (0.093") acrylic, it chipped and cracked the panel. Polycarbonate doesn't shatter, so you should be good for almost all thicknesses.
When used correctly, these blades make very clean cuts with no chipping at all. The edges look as though they were laser cut! I was a bit skeptical, but they work well for what they are designed for. Not too expensive, either. Good job, Bosch.
June 5, 2015
Rated 5.0 out of 5.0 by bikepainter Worked great on HDPE 1/2" sheet
The blades are described for cutting Plexiglas, but I was cutting HPDE plastic about 1/2 inch thick.
They blades performed beautifully and the edge required very little finishing.
December 8, 2015
Rated 5.0 out of 5.0 by sully1 worked well
used this blade to cut 1/8" thick Plexiglas sheets, 2 ft and 4 ft straight cuts. Blade worked well, smooth cut, no melting. I clamped plywood under and over, right to the cut line to prevent chipping, also clamp a guide on top and go slow.
September 8, 2015
Rated 5.0 out of 5.0 by jdrewf Clean For Plexiglas - 3-Pack
I purchased the Bosch 3-5/8 in. x 10 TPI plastic-cutting jig saw blades to cut through 1/8" Plexiglas panels. The blades worked as expected no tear out, splintering or cracks, they are perfect for the job.
February 25, 2014