Rated 3.9 out of 5 by 18
Rated 5.0 out of 5.0 by rayhawk08 above and beyond.
very good product I had never seen a spade bit made like this one. curved arms instead of straight . the tip had what seemed to be a threaded end which made the spade bit almost do all the work. great tool looking forward to much more use. Gratefully
August 30, 2016
Rated 5.0 out of 5.0 by rickinNH MAJOR IMPROVEMENT OVER FLAT PADDLE BIT
Works nearly as well as a forstner bit! Drilled out 16 holes 1 1/4" dia by 1 1/4' deep in dried southern PT with 1 battery on a little Milwaukee M12 impact!
July 12, 2016
Rated 3.0 out of 5.0 by AArmystrong Average
Not sure if it was my drill or the drill bit , but it had a hard time going through a regular 2x4. Had to drill 12 holes, by the time I got to the 4th one the bit seemed dull. Served the purpose for the price
May 31, 2016
Rated 5.0 out of 5.0 by mike I screwed it up (Get It)
Works doesn't break. Quick job. SUPER AWESOME YEAH!
April 12, 2016
Rated 5.0 out of 5.0 by Josef Great buy!
Everything about the Daredevil spade bit hold to be true.
February 18, 2016
Rated 5.0 out of 5.0 by David Works perfectly and Quickly
This was the first time I purchased the "daredevil" and it exceeded my expectations!
December 15, 2015
Rated 5.0 out of 5.0 by AnuC Excellent Bit
I used this bit to drill through the bottom of a cabinet for setting a new microwave.
The hole was to push the power cord head through. This bit is the perfect size for the 110V cord.
This bit has a threaded tip, which grabs quickly, and pulls itself through the wood effortlessly. Very little splintering.
Highly recommend this well designed bit.
April 28, 2015
Rated 1.0 out of 5.0 by vfr1200 Overly agressive
It's a well made bit - BUT - once the threaded auger portion of the bit penetrated far enough into the work to gain purchase, it pulled the work up into the bit with such force that it shredded the work and stalled the drill so completely that it was in danger of being burned out (smoke was coming from the motor). It might be a good choice if you are using a very heavy duty drill and planning to drill completely through the work, but I wanted to cut a countersink hole for a fender washer and bolt so the head of the bolt would be flush with the work surface. It was very difficult to control and over-drilled the depth of the hole. I gave up and used my plunge router for the rest of the holes.
June 9, 2014