Rated 4.5 out of 5 by 35
Rated 5.0 out of 5.0 by DataDon Tops
Amazing the difference between regular flat bits and these in speed. Absolutely worth the extra cost.
May 3, 2016
Rated 5.0 out of 5.0 by aesch Good bits. Need a lot of torque.
Bought these bits and the 6" extension to drill a wiring hole through some joists with an odd spacing. I have a 'Hole Hawg' with the Milwaukee self feeding bit and the 12" extension, but there was no 6" extension available. These bits did the job better than expected - bit into the wood and cut through cleanly. The spade design leaves a lot of space for chip clearance.
Only caveat is that these bits need a drill with a lot of torque. My 3/8" corded drill wouldn't turn them - had to use my low speed 'Hole Hawg'.
March 23, 2016
Rated 5.0 out of 5.0 by Verified Reviewer super dupper spade bit -- best I have ever owned
I have been boring holes through 2x8s and this works great. It would be nice if the shaft were longer so you could get a deeper hole
March 8, 2016
Rated 5.0 out of 5.0 by rosif3r good smooth holes without draining your battery
Best spade bits i've used yet (i bought 3 sizes at the same time, only had time to use one but i'm sure the others are the same, just different diameters). Don't forget to drill the pilot hole, and have the drill on the slower speed (fast is too fast for these bits).
December 2, 2014
Rated 5.0 out of 5.0 by mattandbucs Great Bit
This bit was great. It did all the work. I used a low power drill and this bit just tore right through the wood and made easy work. I can't wait to try it with a regular drill.
October 27, 2015
Rated 5.0 out of 5.0 by dyleone in wood drilling nothing compare with this
With these bits, drilling wood studs is like drilling cheese.
September 15, 2015
Rated 5.0 out of 5.0 by cabindwellers make drilling effortless
The bits made it a breeze going through the studs quickly. Made getting the cabin ready to wire so easy
July 12, 2016
Rated 5.0 out of 5.0 by TheSafetyGuru Fast n furious
I liked it. It grabs into the wood and won't let go until it gets thru.
July 12, 2016