Rated 3.6 out of 5 by 52
Rated 4.0 out of 5.0 by trogo Quality Wall Scanner
I was frustrated buying cheap, throw-away stud finders that never seem to work when you need one, so I stepped up to the Bosch GMS120 Professional Wall Scanner. It comes with a nice flexible storage case with hand lanyard and belt loop. Using this wall scanner is not intuitive and requires reading the instructions thoroughly. There are multi-colored flashing lights, changing bar graphs, symbols and sounds that requires prior working knowledge to use properly. The instruction pamphlet would benefit from better graphics and illustrations.
The scanner has three modes; wood, metal or live electrical. In the wood mode it actually scans for all three, and will display the various signals and graphs on the display. It also identifies the center point of wood studs or metal objects. Selecting metal mode excludes wood and scans for only ferrous/non ferrous metals and “live” electrical wires. It is important to note that the scanner detects wires where current is flowing. The warning light may not flash for wires that have no current draw.
The Bosch GMS120 performed very well in all three modes during my testing and use. As recommended in the instructions, I used a thin piece of cardboard over the uneven ceiling texture, and it detected the joists perfectly. Now I don’t have to drill and patch holes in the ceiling when looking for the joists. The scanner could be more user friendly with better graphics in the display, but it’s still a giant leap above the cheap stud finders.
April 25, 2013
Rated 5.0 out of 5.0 by Nikki Great features.
The features are great...takes the guesswork out of locating the studs, etc.
January 13, 2015
Rated 5.0 out of 5.0 by baks A very good product to purchase
works really good. it detects 3 different finders. wood, metal, and hot wiring. would recommend this product.
March 26, 2015
Rated 2.0 out of 5.0 by Doresoom Disappointing
This stud finder really sounds like it does it all: find studs, live wires, and metal in the wall. However, I was very disappointed that it didn't perform better for the price. My $15 stud finder outperformed it on several of the walls that I tested it out on, which is inexcusable in my book.
- The stud finder is a little bit larger than most I've used in the past.
- Bosch packed a lot of features into this, including a 3-color led indicator, a signal strength display, a backlit display, the option to turn sound indications on/off, and the option to turn the backlight on/off.
- The through-hole for marking stud locations is a pretty cool feature too.
Wood stud detection:
- The main application I planned on using this for was locating studs. I started over an electrical outlet, since I knew there should be a stud on one side of it. I used both stud finders (my old one and this one) simultaneously, and my old one lit up reliably every 16", turning on and off for each side of the stud. The Bosch gave me intermittent indications, some of which were right in the middle of the 16" spans. The centering feature is OK, but requires that you backtrack once you reach the far side of the stud. Even then, it usually gives about a 3/4" range that it calls the "center."
- The best-performing feature is the metal detecting capability. This is the only reason I'm giving it more than one star. I do a bit of woodworking, and missing a nail before I send a board through my planer can cost me $50-60 on a set of knives. So if I find two nails, the scanner has paid for itself. I tried it out by holding a screw on the far side of an 8/4 walnut board, and the scanner gave a strong indication when I passed over the screw's location. It couldn't find a staple through the board though, but it can detect a sewing needle from about 1/4" to 1/2" from the scanner, without anything in between.
- If you want a more reliable stud finding method, I'd use the wood detection capability in conjunction with the metal detection feature. Find the general location of the stud with the wood detection, then use the metal detector to scan up and down to find the screws.
Live wire detection:
- This thing is garbage when it comes to finding live wires in your walls. I can scan all around electrical outlets and light switches without so much as a peep from it. My old $15 stud finder lights up like crazy when I scan the same areas. I even scanned the extension cord powering an overhead light in my garage, and the Bosch scanner couldn't pick it up even when I touched them together! I had to rub the wire all over the scanner until it lit up. I would definitely NOT trust this thing to find a live wire before I drilled into the wall.
- Unless you are buying this in part for the metal detection capabilities, go with a different scanner. Even then, you may still be able to find a separate stud finder and metal detector for about the same total price.
May 19, 2013
Rated 5.0 out of 5.0 by hobbistlan Great scanner
This scanner is so easy to read . It can find studs in walls that other scanners cant find. It is lightweight and so easy to get into places that you cant do others
March 3, 2015
Rated 1.0 out of 5.0 by AVXFlyer Quality not what I expected
It was time to treat myself to an upgraded tool to replace my ten year-old stud finder. I bought the Bosch with the thought it was a high-end tool. The device isn't intuitive and requires multiple references to the manual. Most notably, the "Live" wire feature didn't pick up any live wires at all. I tested it against a power cord for a radio and then it worked, but wouldn't pick up electrical in known locations. The first stud it identified now has a molly bolt in its place. This tool is going back.
February 9, 2015
Rated 1.0 out of 5.0 by graz Bosch stud finder
I tryed over and over for it to find a stud and I had more luck knocking on the wall. I returned the item and got my money back. Dewalt is coming out with a stud finder so I will wait and try that one.
December 10, 2014
Rated 1.0 out of 5.0 by Thompson I got a bad unit...
My unit wouldn't pick up anything correctly, wood, metal or electrical. It gave out false readings constantly and led to much aggravation. After some online research I discovered that Bosch sent some faulty units to the states. I called Bosch and they confirmed the bad units being shipped over to the U.S. I attempted to return it to the Home Depot store where I bought it only I had lost the receipt and the store had pulled the stud finder from their shelves so they refused to take it back. Now I am stuck with an $80 paper weight. I will purchase a new one because I trust Bosch products but I will not buy it from Home Depot.
August 27, 2014