Rated 4.1 out of 5 by 61
Rated 5.0 out of 5.0 by MPT DIY First Timer
If you aren't afraid of DIY projects, this will be manageable. Do not install on a flat roof. Don't forget a couple of nails, hammer, jigsaw, extension cord, duct tape, roof cement, a mixer, and a brush to apply the cement.
April 14, 2016
Rated 4.0 out of 5.0 by Troy great buy
But you need a 4 inch insulated vent hose to vent out a bathroom fan, fyi. To vent a range hood a 4 inch metal pipe is rec. Other than that works great.
June 15, 2016
Rated 5.0 out of 5.0 by RhodesRenovationsInc Nice, high quality product
Easy to install. I like this vent because it id heavy duty steel that will not dent easily.
May 31, 2016
Rated 5.0 out of 5.0 by FunTiling Good product
This is a very good product, good price and good quality,
Very thoughtful design, built in back draft damper and bird screen.
Easy to install. Instructions are very clear too. Thanks to HD carrying this product.
April 26, 2016
Rated 5.0 out of 5.0 by Axle Best you can get
There are a lot of cheap, thin bathroom exhaust vents out there, this one is the best.
April 30, 2016
Rated 5.0 out of 5.0 by nickname1 Nice roof kit
The roof vent kit was very easy to install, and works as it should. It looks like it should last a long time, it was well built.
April 1, 2016
Rated 3.0 out of 5.0 by plumbbob adequate
I have used this kit several time now with different customers. It is probably the absolutely cheapest materials and design that gets the job done. A few gripes: the "bird" screen falls out very easily, the screw in attachment to the vent is a little hit or miss especially in a tight space. Make sure you spend plenty of time to perfectly align the unit under a full shingle and seal properly. The instructions are good (if you read them!). Remember that there is little room for error when making holes in your roof.
February 10, 2016
Rated 4.0 out of 5.0 by Bohocanary Good value, easy to install
I bought two of these kits as I had two bath fans which were exhausting to the attic. They had excellent instructions and went in easily. Only suggestion would be to include the sealing tape in addition t the tie wrap for a code complete kit. One installation as a straight shot from the fan was pretty close to the peak of the roof. This one catches the wind and so makes a bit of flapper noise on a windy day. Maybe an added note to the instructions that this may no be the best place, and a little angle on the vent line is OK.
April 1, 2014