Rated 3.5 out of 5 by 22
Rated 1.0 out of 5.0 by Homeowner Do not buy this vent kit- you will be disappointed.
The durability of this low quality kit is reflected in the low price. The components are very cheaply made, and I would not recommend it for venting anything. The kit comes with only five feet of cheaply-made duct, hardly enough for most applications. The wall vent itself is also of very low quality in terms if the thin gauge aluminum and plastic used. The metal and the plastic will bend or break if you exert even relatively little force on them during installation. The kit comes with a piece of foam insulation with adhesive on one face, but there is no reference to its use in the instructions. Not a good choice for venting a bath fan.
September 13, 2016
Rated 4.0 out of 5.0 by bjbuenger Worked well. Hose was too short for what I needed. Replaced tie straps with worm clamps. Over all it worked out very good.
October 25, 2016
Rated 4.0 out of 5.0 by kentuckydust It does the job
The kit does the job for a vent fan. The zip tie to hold on the flexible tube is the weakest link but if you pull it tight with pliers it works. I have used this product for 2 fans with no problems.
September 27, 2016
Rated 4.0 out of 5.0 by Phen Exactly what I needed
Good product for the price. Fairly easy install. It's a basic vent.
August 9, 2016
Rated 5.0 out of 5.0 by xgregx Good vent kit
I had an easy time installing this. Cut a hole in the wall and attached the outside vent. They give you plenty of length to work with.
July 1, 2016
Rated 4.0 out of 5.0 by K1 Good product
Great price, good product. Door flaps a little in the wind, other than that, no complaints. Very easy to install.
May 17, 2016
Rated 1.0 out of 5.0 by Ken flaps in the wind and makes noise
Since I'm having to redo things to remove this I'm giving it 1 star. I have three of them two of them are higher on the house and when the wind blows they flap lifts up and smacks back down. Really annoying. I'm going to put in a louver vent.
July 4, 2015
Rated 4.0 out of 5.0 by CARPENTERINPA57 PRETTY NICE EXCEPT FOR THE TEMPLATE
Installation tip! The template they give you to mark the cuts in your siding is too large! The template has squared off corners and the actual product has rounded corners, This resulted in a large gap between the vent frame and the siding. It can be easily filled in using silicone calk but if it's in an area the is visible, you will be disappointed with the appearance. For once, I followed the directions when I wish I hadn't. I suggest tracing around the actual door frame to mark the outside frame cuts. You will get a much more accurate and better looking installation. After cutting the siding, you can use the template to mark the hole for the vent tube. I am pleased with the operation so far. I was concerned because I had a run of about 15 feet and was concerned that the fan might not be powerful enough to open the door when turned on but it operates perfectly.
April 28, 2015