Rated 4.2 out of 5 by 109
Rated 3.0 out of 5.0 by Richard shutter lok fasteners
The fasteners were not as sturdy as required to hold the heavy shutter. Each would bend as it was hammered into the siding. I broke 3 of the six fasteners during installation.
October 21, 2016
Rated 1.0 out of 5.0 by David The Worst Fastener I've Ever Used
I was attempting to replace the old ones that broke, but once these are about halfway into the hole, they begin to bend and will not insert any further. I tried everything I could think of, but fighting with these fasteners from the top of a 32 foot extension ladder was becoming dangerous. I'll return these and use reliable concrete anchors. I'll probably save some money.
March 29, 2016
Rated 3.0 out of 5.0 by Bobcat Plastic fasteners
These look ok, but they are just cheap plastic. An option for metal would be great.
September 20, 2016
Rated 5.0 out of 5.0 by Auntiechar Simple to use, does the job
Drill the hole, insert the fastener and use a portable drill to seat. 16 shutters installed in less than a hour with these fasteners without and problem.
July 26, 2016
Rated 4.0 out of 5.0 by Leif Effective fasteners
Worked well. Some have more distinct mold flash than others.
May 31, 2016
Rated 1.0 out of 5.0 by dano Useless shutter locks
75% of these shutter locks were too flimsy, and did not work. They disintegrated with gentle taps with a hammer. The installation instructions indicated they could be tapped with a hammer. They flat out could not be used to fasten the shutters to the house and our contractor had to go back to Home Depot and find another solution. Waste of time, money and patience. Don't buy these.
May 7, 2016
Rated 1.0 out of 5.0 by NitPicker Shutter Lock Fasteners
Shutter Lock Fasteners
Here is why my shutter fasteners are breaking.
It only happens on my shutters that are fastened to brick facing, and only those fasteners on the top or bottom of the shutters, not the ones in the center. The shutters that are fastened to vinyl siding have yet to break.
The reason is the shutter holes do not align with the holes drilled in the mortar between the bricks (where you tend to drill the holes). The difference in distance is off by as much as ½ inch. Consequently, the end fasteners take the brunt of horizontal stress and in time break.
Another point is that the fasteners that are breaking have a flush button head; where the replacements have a raised button head, and are a bit larger in the head and shaft; these have yet to break.
Maybe the manufacture has redesigned them???
April 26, 2016
Rated 5.0 out of 5.0 by milo37 Easiest fastners
These were the easiest fasteners I've ever used. Made the installation go faster and held the shutters securely. They supply plenty of extra fasteners as well so we have replacements if they are ever needed and I don't foresee that at all because they are so well made.
October 18, 2016