Rated 4.5 out of 5 by 116
Rated 4.0 out of 5.0 by Novice New installation great, replacement much harder.
Replacement can be a task. Cut caps of shutter plugs on the outside of shutter. Use a 5 in 1 tool and hammer sideways. Try to pull all of plug out next with a pair of pliers and wood to protect your siding. If it is in a solid surface you will need to drill out the old plug, use a drill bit smaller than the plug and pull out all remnants of the plug. Take the old shutter and align with new and drill same size holes into it. When installing new shutter to old holes, make sure to not hammer to hard and use care that is doesn't pinch the shutter.
July 19, 2016
Rated 5.0 out of 5.0 by Doug Nice vinyl shutters
Easy to install on brick if you have a good drill and masonry bit.
January 27, 2016
Rated 4.0 out of 5.0 by Fergie product is good
The only complaint is that the products boxes were all damaged during shipping (UPS). Able to use
scuffed sides because they were not visual after installation.
December 8, 2015
Rated 5.0 out of 5.0 by Lucidog Can't believe it's vinyl!
After repairing again the slats of two shutters, we decided to replace the shutters with vinyl shutters. They looked cheap when we first took them out of the box. But once they were installed they looked great!!! Our painter installed them and said it was easy.
The only negative is they are online only. After purchasing two different color for comparison, we returned one and ordered more of the chosen one. Each order is a 10 day turnaround. Worth the wait as long as we are not charged for restocking fee.
September 1, 2015
Rated 5.0 out of 5.0 by Guitarman53 Huge Improvement in Appearance
We are very pleased with the appearance of our new shutters. Easy to install, just measure and follow directions. The shutters look so much more expensive than they actually were. Loved the color, too!
June 28, 2016
Rated 4.0 out of 5.0 by DIYourselfer Good Product With Marginal Fasteners
I ordered the 48" shutters and had them delivered to our HD store. The first set was damaged in shipping and HD handled the return.
The shutters come with flimsy plastic push fasteners which at first I didn't think would work with our brick siding. I ruined a fastener before figuring out what works best.
You will need a hammer drill with a 1/4' masonry bit. The key is to drill the hole in the mortar between the brick at least 1/4" deeper than the length of the fastener the first time. Once you put the fastener in the hole it's hard to get it out again and you will probably ruin it.
Another tip is to slightly enlarge the hole through the vinyl shutters so you can easily slide the fasteners through the vinyl and into the hole drilled into the mortar.
I inserted each fastener about half way by hand and then used a rubber mallet to gently tap it in the remainder of the way. The shutters really dressed up the appearance of our house. Good luck!
August 27, 2016
Rated 5.0 out of 5.0 by Paloma Vinyl Exterrior shutters
The product was lightweight no assembly, only installation.
August 9, 2016
Rated 4.0 out of 5.0 by Bill About what I expected
Easy to install, accurate sizes, and they are nice accents to our new windows.
August 3, 2016