Rated 4.6 out of 5 by 22
Rated 4.0 out of 5.0 by DL Water Heater Anode Rod
Arrived ahead of time and is as described. I cut the rod to length in order to fit it into water heater.
September 22, 2016
Rated 5.0 out of 5.0 by LeeMk Lots of torque needed to remove old rod.
I am using a second hand electric water heater tank in a solar water heater. Lucky I removed the old anode and checked. The water heater was much older than the seller claimed and the anode was 98% gone. I had seen excessive rust on the inlet, outlet and pressure relief welded bosses. That was the clue that the anode was eroded and failing to protect the tank.
Replacing the anode requires over 200 foot pounds of torque to unscrew the old anode. I used a 1/2 inch breaker bar, 1 1/16" socket, a 5 foot 1" piece of pipe (for leverage on the wrench), a 4 foot long 2x4 (to prevent the tank from spinning), safety glasses and gloves. Clean hole with pipe tap. Use pipe dope on new item.
June 25, 2016
Rated 4.0 out of 5.0 by wildhorse Good deal
Everything was as decribed but 1 of the rods were bent but we got it straghtened out and it worked.
June 14, 2016
Rated 5.0 out of 5.0 by Cary IT WORKS FOR ME!
I purchased this anode rod for a electric water heater that I purchased from Home Depot about 4 years ago. I live in the northeast and my rod was corroded with only 30% remaining. The problems started with little air coming out of faucet when I turned on the hot water. Then I started getting rusty (hot only) water. I changed the anode rod and within two days the rusty water stopped and within a week the air stopped coming out of the faucet when I turned it on. Its been a month and a half and no rusty or air in the water.
April 15, 2016
Rated 5.0 out of 5.0 by tjones5153 Resolved the issue with hot water heater
Purchased a new water heater for our country house in Alabama. The hot water had a sulfur smell when not used for a short time. Goggled it and the issue is the type of anode in the new heater. I used a impact wrench to remove the old anode and installed the new. Ended up being very simple and solved the problem instantly. I was worried about the size etc and it appears there is a standard. I recommend to anyone with the same issue.
December 8, 2015
Rated 5.0 out of 5.0 by Tonuch Hot Water tank replacement Anode Rod
Sufficient headroom above tank to remove and insert new Anode rod, air impact wrench and 1 1/16" socket, thread sealant and new anode rod installed.
Good quality, great price.
December 8, 2015
Rated 4.0 out of 5.0 by Dick Routine maintenance part for me.
It appears that very few people do this maintenance chore to extend the life of the tank and heating elements. The aluminum anode is recommended for the hard water in this area. It is a relatively easy job to change the anode rod in a water heater. The standard length of this rod is now 48 inches; I could have used a longer rod for our water heater.
November 10, 2015
Rated 5.0 out of 5.0 by DIY Fast shipping great price, works perfect
Works perfectly, had to cut to length, tape threads and install, threads were a perfect match, no issues installing, Got rid of the rotten egg smell.
September 26, 2015