Rated 3.9 out of 5 by 21
Rated 1.0 out of 5.0 by PaulR Junk - Leaks
Packaged as "Husky" brand. Upon installation this product leaks out of the drain at the bottom. Drain valve is cheap plastic, no matter how I turn it, it leaks, and cannot be tightened up. Save your money and aggravation and buy a quality product. Regulator I bought separately seems to be working well, no complaints there.
September 13, 2016
Rated 5.0 out of 5.0 by ron Feeling drained
So far i have only used it once but all i can say is it works.... I have 2 Craftsman filters and they don't seem to work as well I especially like the drain for the water build up. My Craftsman filters do not have a fixed drain plug and I have lost the small screws on both multiple times . The fixed plug makes draing mid service a breeze ....
October 4, 2016
Rated 5.0 out of 5.0 by DIYgal nice filter
I do slot of painting projects as an artist and this is a nice product to use. Helps keep my air lines clean.
October 4, 2016
Rated 5.0 out of 5.0 by Alex2016 good filter
Has totally elimnated any leakage...I use my air tools pretty frequently and i'm very satisfied with how this filters operates
October 3, 2016
Rated 5.0 out of 5.0 by GarageGuy Best Purchase - Love CH
A filter that does what an air filter is supposed to do; if you want clean results then this is the product for you
October 3, 2016
Rated 5.0 out of 5.0 by mikePlugOne good filter
The product does its filtration, is leak free allowing for clean, polished results. super satisfied
October 2, 2016
Rated 4.0 out of 5.0 by Itsanss So far, so good
Running a DA sander for an extended period made for a LOT of water coming out of the tool. Finally invested in a filter and settled on this one. I've used the sander several times since I've installed the filter and the compressor has run for an hour straight several times. I would say that it has cut the amount of water coming out of the tool by 98%. There's still a little water that comes out, but it's nothing like it was pre-filter.
******I will say, however, that at the same time I installed this filter I also installed approximately 30' of 1" steel pipe. From my research I knew that the filter performed best as close to the tool as possible. Well, in this case that's simply not possible. I needed the filter right by the compressor, before my air hose reel. To compensate for this I wound up running 4' of steel vertical pipe up through the ceiling into the attic where it 90s to a 10' horizontal stick, where it 90s again to another 10' horizontal stick that slopes downward and back towards the compressor and then 90s down to a vertical 4' stick and on the end of this pipe is where the filter is. So my filter is still next to the hose reel, but there is ~30' of pipe between it and the compressor. Bottom line is the filter is working exactly as I'd hoped ON MY SETUP; your results may vary/may not work at all if you don't have enough pipe/line before the filter to allow the air to cool before it gets to the filter. Read online if you don't know what I'm talking about.*****
May 3, 2016
Rated 1.0 out of 5.0 by RetPilot Cheap drain valve; leaked fresh from the box
The small plastic drain valve is sloppy; of low quality with poor tolerances. It leaked right out of the box, no matter what I did to try to stop it. Returning it to HD store where I bought it, with the atendant brass connectors and will be wary of Campbel Hausfeld products despite being a longtime owner of other items from them.
November 28, 2015