Rated 4.5 out of 5 by 56
Rated 3.0 out of 5.0 by Tony Easy to Install
Easy to install but would have liked it better if if would have fit the original brackets better. New brackets were to flimsy and didn't fit the sensors well. Also slightly pricey.
February 10, 2016
Rated 5.0 out of 5.0 by Rob 94 Craftsman 1/3HP
Works fine on a Craftsman 1/3 HP opener dated 1994.
August 7, 2016
Rated 5.0 out of 5.0 by Fc1173 Easy peazy
Great product easy to install. Worked with my garage no issues
August 2, 2016
Rated 5.0 out of 5.0 by Gramps Easy replacement for old Stanley
I had to modify the mounting bracket because it would not snap on my door track and the wiring was a little different. Overall after mounting rest of install was a snap.
July 12, 2016
Rated 5.0 out of 5.0 by jcb10 Works Like a Champ!
Easy to install. My garage door had a problem with retracting while trying to close mainly when the sun was dead on the door. Since the retracting is related to the safety beam across the bottom of the door opening, I decide to replace the two sensors. Works like a champ now, every time.
May 31, 2016
Rated 1.0 out of 5.0 by Allan Replacement Safety Sensors
I bought a set to replace the ones that were no longer working. I installed the set and they worked fine for 2 months and the one with the green light went dead! I checked all the wiring from the sensor to the opener unit and it was fine. The orange lighted sensor is on but the green one is unlit. I am very disappointed and will have to order another set of sensors,
July 2, 2016
Rated 5.0 out of 5.0 by Lindy Worked on my 1993 Craftsman model just fine!
My old 1993 garage system was installed when the house was built. It's an old '93 Craftsman 1/2 HP with the original safety sensors. Just this past week, our garage would open but wouldn't close without holding down the main control. At first I thought it was the remotes, but when my 'homelink' didn't work either in my car, I knew it was something else. After researching and youtubing, I learned it was our safety sensors. Our receiver unit was lit green, but the other one was blank (no light). I found these on HomeDepot, but it said it was not compatible for my model since it was a '93. I read the questions and reviews and noticed a couple others had tried it on their older models, so why not give it a shot.
So today, I purchased them at Home Depot and saw that the wires were identical to my existing sensors. I cut out the old sensors and mounting brackets out and spliced the wires together and what do you know. It works like new! At first, I wasn't a fan of the mounting hardware that is included, but it was actually pretty simple to mount to the rails. Got everything lined up, and works better than my old sensors! Very happy customer! I highly recommend these if you need new ones. And don't be afraid if you have an older model. Just look at the wiring and make sure you connect it correctly!
February 17, 2016
Rated 5.0 out of 5.0 by Sam Sensors fit fine
Installed these on a 1994 Craftsman opener and door.
They fit just fine in the original brackets.
Only took about 20 minutes.
February 17, 2016