Rated 4.7 out of 5 by 14
Rated 4.0 out of 5.0 by TeeAreCee Did the job.
This is what I needed to get the 3 1/2" slip-joint nut off the bottom of the toilet tank, so I could remove the flush valve.
April 27, 2016
Rated 2.0 out of 5.0 by Blahhh Expensive
Doesnt fit on smaller things....... Only large pipes
March 8, 2016
Rated 5.0 out of 5.0 by gMusgrove Right Tool for Right Job
Needed a wide mouth to work on the commode and this did the job.
October 13, 2015
Rated 5.0 out of 5.0 by drew made in usa
great tool. even better, its made in the good old usa
October 6, 2015
Rated 5.0 out of 5.0 by JerryY Plumbing Life Saver!
While this is an "oil filter wrench" I found it to be a life saver on a plumbing project. My new house has a toilet with a 3" flapper which made the nut holding the fill valve on 3.5". I couldn't find a wrench that would fit that size of nut but this would.
I literally spent 30 minutes using every other tool I had (strap wrench, vice grips, hammer and a screwdriver, etc) to try and remove the nut. Finally as a last ditch effort I bought this setup and about a minute later I had the nut loose.
July 9, 2015
Rated 5.0 out of 5.0 by Nedflanders Of course
With 7 cars in the family there's always one that needs this wrench!
August 26, 2015
Rated 5.0 out of 5.0 by oilman Best tool ever!
So after struggling, and saying a few choice words, for 3 hours with a stuck oil filter I went to my local Home Depot and bought this wrench. I kid you not in less that two minutes it was loose. Now let me say I had tried two other wrenches and even had bent and punched a small hole in the filter before I gave up and bought this wrench so its not like I hadn't tried to get it off! Amazing this is the only oil filter wrench you will ever need so go ahead and throw
away all the others!
December 27, 2014
Rated 5.0 out of 5.0 by SteveE Just what I needed, worked great
I bought a new mower two months ago and at the 8 hour mark they suggested an oil change and a new filter. I tried for an hour to get the filter off, using a oil filter wrench and an oil filter cap wrench and after the hour of busting my knuckles and cursing I drove to the nearest store and purchased this item. It took me all of a minute to get the filter off after I got back home. Making the gallon of gas, hour to get it and the $15.98 + tax all worth it.
Only used it once, so I can't really say much about the quality or if it will last, but since I will only be using it once a year, I figure it will be a good value. Just wish the mower's manufacturer wouldn't have put the filter on so dang tight to begin with.
June 29, 2014