Rated 4.4 out of 5 by 67
Rated 4.0 out of 5.0 by MasterBarber Seen ok so far.
Had this unit Installed in a ventless bathroom that gets cold during the Winter. Install took about an hour, because the wood in the wall was thicker than expected and harder to cut through. Overall the unit is a good value for the cost and also looks good cosmetically.
Pros: Cost, installation, small footprint, solid looks, heats room well.
Cons: No on/off (you can turn it all the way down which basically is almost like an on/off switch.
Gets hotter to touch than I expected based on reviews. Surface Gets to hot to hold your hand against. I plan to post a warning sign for surface heat.
Seems to blow harder toward left side than centered, or all around vent.
Overall I would by again.
February 14, 2016
Rated 4.0 out of 5.0 by Warmer2014 Made for new installations
Bought this heater for a basement bathroom that was already finnished. I made it work, but this heater is made to be installed before the drywall is installed to be able to connect the opposite end of the heater to either the left or right hand stud. If you are installing in a finnished wall you can only attach it to one stud. The cross bar that slides into the top to connect to the other stud can't be used. Other than that the heater works just fine.
January 4, 2015
Rated 4.0 out of 5.0 by SER53 Good but a bit noisy
I installed both the Broan Comfort-Flo (12 in. 1500-Watt Wall Heater, 750/1500W 120VAC,1125W 208VAC, 1500W 240 VAC) and the another heater and will compare. Broan is nice because it is multi-wattage/voltage while the other is single voltage/wattage. I'm using the 120v/750W mode and it heats the bedroom nicely. The Broan is at least 3x as noisy vs. the other. Broan is good for bath or bed (if you can sleep through it-we're getting use to it). For the price, the broan is good. I will put more Broan's into the bath. I liked the Broan because it's a horizontal heater and more modern looking and doesn't extend from the wall much. Very easy to install. We also use external thermostats for better control.
December 17, 2012
Rated 3.0 out of 5.0 by seller Needed to have to sell home.
We have approx a 200 sq ft addition with no heat. We have been using a freestanding unit ($60), which heated the room great. In order to included the area for selling, we had to install this. It does not heat the area as well as the free standing unit. It is noisy and heats the back side of the wall it is installed in.
March 2, 2016
Rated 4.0 out of 5.0 by Fred312 Best price
This unit has a build in thermostat and for the doit your self weekend warrior is easy to install. I'm running mine on 110 v as a secondary source of heat in a small bedroom. It only comes on as needed and does the job intended. The price is right for a unit that is self contained.
October 27, 2015
Rated 5.0 out of 5.0 by chcl3 Good heater for the price
Installed in my remodeled bathroom, took out my old radiator to save room. Haven't had to use it yet as it is warming up now, but it does work and put off a good amount of heat when I tested it. I don't anticipate any issues with performance, it is not overly noisy, but living in NY I have a higher tolerance for noise. Some reviews said it was too noisy, I don't think it is that bad. I installed it with a switch as the unit only is regulated by a thermostat, I prefer knowing I can turn it off if I want. All in all, it was easy to install, looks, and functions well. I recommend this heater.
June 2, 2015
Rated 5.0 out of 5.0 by dmm3814 Excellent wall-mounted bathroom heater
The heater was easy to install and great for the price. The only two issues that I have with the heater are: 1) The knob is cheap plastic and will probably break after a little bit of use and 2) it does not have an on/off switch. It has a knob to adjust the temperature but no on/off switch. I suspect that the heater probably will not cycle on in the lowest setting unless it is near freezing. However, I would still feel more comfortable leaving the house knowing that the heater is off. I would recommend installing a light switch to control the heater when you install the heater. The heater does have to be wired.
January 18, 2015
Rated 4.0 out of 5.0 by Vic Inexpensive, reliable, and efficient heater
I had to install a wall heater for appraisal purposes, so I installed this heater and after I finished the installation I realized that it worked as well as the portable heaters I have for each room. Good purchase in general that serves well the purpose of a small electric heater.
July 14, 2015