Commercial Electric 3-Light 4 ft. Fluorescent Wraparound White Surface Mount Fixture-CEW103-06 - The Home Depot
Discontinued

Commercial Electric

Model # CEW103-06

Internet # 203725965

Store SKU # 195588

3-Light 4 ft. Fluorescent Wraparound White Surface Mount Fixture


Commercial Electric 3-Light 4 ft. Fluorescent Wraparound White Surface Mount Fixture
 

This item has been discontinued.
The Home Depot no longer carries this specific product.

$35.00 / each
Loading...

PRODUCT OVERVIEW

Model # CEW103-06

Internet # 203725965

Store SKU # 195588

Commercial Electric Fluorescent Wraparound surface mount fixture, gives out diffused light, blends well with any kind of decor in the house. The light provides you with enough energy savings while remaining environmentally friendly. It has received an Energy Star Certification and is also ETL listed for safety

  • Blends well with any kind of decor in the house
  • High quality steel construction
  • Sleek styled narrow wraparound
  • Limited three year warranty
  • Easy to install
  • Durable non yellowing acrylic lens
  • Uses (3) F32T8 lamps (not included)
  • 120-Volt residential instant start electronic ballast
  • Starts reliably to 0° F

SPECIFICATIONS

Dimensions
Product Depth (in.)  48.75  Product Height (in.)  2.25 
Product Width (in.) 
Details
Bulb(s) Included  No  Collection Name  N/A 
Color/Finish Family  White  Commercial Light Type  Work Light 
Fixture Color/Finish  White  Hardware Included  Yes 
Light Bulb Base Code  Bi-Pin  Light Source  Fluorescent 
Number of Bulbs Required  Product Weight (lb.)  5.55 lb 
Returnable  90-Day  Wattage (watts)  32 W 
Warranty / Certifications
Certifications and Listings  ETL Listed  Manufacturer Warranty  N/A 

CUSTOMER REVIEWS

Rated 3.6 out of 5 by 9 reviewers.
Rated 1.0 out of 5.0 by Terrible fixture The covers fall out. This last time one of them fell and cracked and I cannot find a way to replace it. Not worth the money or the effort. February 21, 2015
Rated 1.0 out of 5.0 by Poorly made light fixture The design of the fixture housing does not properly support the diffuser. The instructions say to raise one end of the diffuser into the end cap of the fixture, raise the other end into position and then slide it back the other direction into the opposing end cap. It is not possible to see if the diffuser is perfectly centered. If it is, there is only 1/8" of support on each end. If it is not, the lens will fall out. The slightest vibration or air current will cause the diffuser to fall out. I have had one fall out and break within 2 hours of installation. If one falls on me while I am working on the table saw it could be a disaster. February 4, 2014
Rated 4.0 out of 5.0 by Good light but cover too short I purchased two of these for my garage. I wanted the three bulb setup to give more light than the two bulb lights I was replacing. The installation was quick and easy. The lights do provide me with a brighter garage than the original two bulb design. The only downside is the light covers are too short. There is only 1/8" overlap for the plastic light cover to rest on the fixture. In two days of opening and closing the garage door, one of the covers fell down. Luckily it didn't break. I'll have to bend the metal fixture or glue some type of "extension" to the plastic cover to make a snug fit. January 24, 2014
Rated 4.0 out of 5.0 by good quality, tricky to install Recently bought and installed 5 of these in my unfinished basement. They look good and are rigid. There are several issues I didn't like: there is very little space for the wiring. In fact, the light has warnings about using higher temperature wires because of the close proximity to the warm bulbs. Unlike the bigger 4 bulb lamps, there is no open center with a built in wire cover. It doesn't come with wire nuts so I suggest using the smallest you can get by with since space is limited. This also means the incoming AC wires have little space. I found it best to keep the bare minimum wire inside the lamp area. The wire knock out hole is firmly attached and can cause problems trying to remove the smaller 1/2 center hole, be careful. The mounting holes do not align with ceiling joists 16 inch on center. Since they don't align with joists, you will need to drill two holes for mounting. Not an easy task while holding the light with the other hand. Being a 3 light fixture I'm sure it will be hard to find a replacement ballast when I need one. The clear plastic diffuser is held in place simply by being physically longer than the light housing. That means you will have to CAREFULLY flex the cover to slip it in place. They look good but I haven't owned them long enough to rate their dependability. This light has a lot of issues and if you don't have the patience or skills to deal with them, I would avoid these lights. In my case, I have limited installation space between air ducts and a suspended gas line, so I had to install a 2 or 3 bulb light. If you're looking for a quick and easy install, I would not recommend these lights. Since I have a lot of experience, this is just another install. July 5, 2014
Rated 4.0 out of 5.0 by Really nice light Installed this thing in an older motel laundry room which was depending on 60 watt equivalent CFLs. What a difference!! The employees couldn't believe they could actually see what they were doing and the owner couldn't believe the energy costs were actually lower. He will likely break even, including my labor for installation, in under a year. I did have to convert it to a power cord sans hard wired which increased the installation costs. July 19, 2014
Rated 5.0 out of 5.0 by Nice bright, quick lighting. Easy to install. I had to add a plug pigtail, but it was super easy. The BEST part is this thing turns on instantly with a nice bright light unlike my old fluorescent fixture I was replacing. January 8, 2014
Rated 5.0 out of 5.0 by Lightweight and great light perfect for lighting my basement area, good quality too, better than the units we bought at another store. January 15, 2014
Rated 4.0 out of 5.0 by Work light functionality Good light for the price, met expectations, interior wiring was on the light side but it's not a big draw so meets expectations. Will have to see over time if the lower power draw makes this better than large bulb version (this was t8 vs t12) to warrent additional expense. Biggest issues is that getting the light cover on takes a little wiggling to get in place without chipping it. July 8, 2014
  • 2015-04-24T11:09:50.183-05:00
  • bvseo_lps, prod_bvrr, vn_prr_5.6
  • cp-1, bvpage1
  • co-hasreviews, tv_9, tr_9
  • loc_en_US, sid_203725965, prod, sort_default
2 >>

SHIPPING AND DELIVERY OPTIONS

Standard Shipping includes delivery by small parcel service. Processing time varies by product.


Orders for this item may be expedited for an additional fee.


Other Delivery Options:

Express and Expedited shipping options are also available. Estimated arrival times are available in checkout.


If product is eligible for shipping to AK, HI and US Territories additional transit time and remote surcharges may apply.