Rated 4.0 out of 5 by 339
Rated 5.0 out of 5.0 by ACHILL32 Great product
Easy to install and great price. Have not had any problems with it.
August 9, 2016
Rated 5.0 out of 5.0 by Champ Do it yourself
Simple to do I followed the instructions and works perfectly and saved lots of money by not calling the plumber.
July 27, 2016
Rated 1.0 out of 5.0 by P938 Cheap quality and NOT UNIVERSAL
We have a Western 1.6 gallon tank with 3" flush valve - this kit will not work with this type toilet!
July 31, 2016
Rated 4.0 out of 5.0 by misterwax Classic Do it Yourself Project
This is a product that takes some patience and some thinking to get it right. However, the cost savings are big and you can get it done right in a couple of hours. A plumber would need the same amount of time because you must remove the toilet reservoir from the bowl in order to be able to work easily. I tested it and it worked just fine on the first flush.
December 8, 2015
Rated 5.0 out of 5.0 by AdamM Worked great!
The tank in my 15 year old Briggs toilet was leaking and kept running the fill valve. Probably a worn flap. But I figured it's best just to replace everything given the age of the old internals -- the old bolts and gaskets looked a bit scary. This kit provided all new parts. They fit perfectly and my toilet was back to new after about an hour of labor. Good instructions and decent quality parts for the price. Much cheaper than paying a plumber.
December 5, 2015
Rated 5.0 out of 5.0 by Richard best ever
I am an engineer so it all should be easy. The directions that I read were written by an engineer not an interior decorator, so it all made sense to me. I had two toilets upstairs that were 15 years old and only the flappers were deteriorated, I could tell since we heard 'ghost flushing' sounds. It went on for a week until I had to repair. I should say replace the entire guts of two toilets. I unbolted the bowl from the tank and replaced the fill assembly and the overflow assembly. All bolts must be tightened with love since you are dealing with ceramic tank and bowl and some of the install parts are plastic, like the overflow 'nut'. Buy an expandable oil filter wrench. It may be a little costly, but you will be able to tighten the plastic nut with ease and sleep at night.
The first one was great no leaks, I went on the second toilet. The first took one hour, the second took about 45 minutes. No leaks. Follow the directions and have your wife or lover assist you. They have smaller hands and can reach the metallic nuts to tighten. Good fun. When it is all done you saved at least $150.00 plumber costs.
May 31, 2016
Rated 4.0 out of 5.0 by DizzyLyzzy Fairly Easy Toilet Fix
We had two toilets with two very different problems. One ran slow as molasses refilling the bowl and the other would get stuck open and run forever until you played with the handle or stuck your hand down the tank to reset the plug. We bought two kits to replace both units. The step-by-step instructions are very clear and fairly easy to follow with minimal additional equipment and no plumber's putty. The molasses toilet is completely fixed, but the stuck toilet still has a problem - you have to close the lid when flushing or the rather large handle gets stuck open on it and the toilet will run.
February 11, 2016
Rated 1.0 out of 5.0 by rlraw Extremely loud!
bought this because our toilet was running a lot. This thing is so loud that when the toilet is flushed (2nd level bathroom) you can't even hear the TV in the basement! I'm so disappointed. The noise has actually woken me up before.
April 4, 2016