Rated 3.3 out of 5 by 298
Rated 5.0 out of 5.0 by Eddy Great Product
Very easy to install as long as you pay attention to the instructions - make sure the surface is wet before installation. I used Fusion Pro (different colors) in my bathroom and the kitchen and like the final product. It is little pricey but the outcome is great!
May 31, 2016
Rated 4.0 out of 5.0 by Jared Grout
Loved the fact that I didn't have to mix this product. And it got better when I didn't have to go back over and seal them either. Did have issues with cracking once everything dried in the areas where water spilled during clean up - also wearing disposable gloves is highly recommended
May 10, 2016
Rated 5.0 out of 5.0 by Mrsed AWESOME PRODUCT!!
We were looking for a grout with an additive for a stronger bond for our project. Fusion was exactly what we were looking for. The color matched the floor tile and the backsplash perfectly and our kitchen is just beautiful!!! We were going to purchase all of our products from a local retailer but found that Home Depot's prices were very competitive and well within our project budget.
May 24, 2014
Rated 2.0 out of 5.0 by DoItYourself Not as good as you would think
I installed a new tile shower April 2015. Not a year later the grout is failing! Not worth the added expense. Now I have to re-grout and this time I will be sealing. It looks good and applies as easily as any other grout I've used. So far it's fine on a floor that doesn't get wet. I do NOT recommend this product for a shower floor though. Stick with the tried and true grout and sealers.
And just try to get a hold of them on their web site via e-mail. Their page doesn't recognize yahoo or gmail as valid.
February 26, 2016
Rated 5.0 out of 5.0 by CJ Worth EVERY PENNY!
Great color choices, never have to seal and mold resistant.
We used this product outdoors and on a covered patio.
December 29, 2015
Rated 4.0 out of 5.0 by C4Net OK, I see why people either LOVE it or HATE it!
OK, I see why most people either love it or hate it! It does make a beautiful seam when finished, but it's not for the average DIY'er. This is a most unusual product, unlike any I've ever worked with. I'm no pro, but I know you cannot apply it like standard cementitious grout because you have nowhere near as much time to work it before it starts to dry. I'm not exaggerating when I tell you that this stuff starts setting up as soon as you pass your float across it! The very fine grit and film that is left behind will dry in like 1-2 minutes AND STICKS to the surface of the tile. (It MIGHT not be as rapid if working in high humidity, but I was in 50% or less) If you float too long/go too far without wiping it off, you will have a fight to get it off. I was laying 6x24 ceramic tile on tub surround walls and could only grout about 36"(1 long edge + 2 shorts) before I had to stop and wipe off. I used the sponge from HD that has the fabric on one side and recommend that one highly because you WILL have to scrub to loosen the grit at times when wiping down and the sponge side alone is not enough! (THAT gives you an idea how firm it sticks!) Well that felt like it was taking FOREVER, so I decided to try applying it with a homemade (Ziploc Qt/Freezer) grout bag. (I had noticed that when the stuff is not spread out thin it dries slower) That worked pretty well with my 1/8" lines that were not too deep. I filled about 36" at a time, with a bead that overfilled about 1/8" above the tile surface. I then came back with a damp 3" putty knife and packed it down flat, 3" at a time, from the side, to ensure fill. Then I scraped along the length to remove most of any excess, which I used on any low spots or tacked on the end where I had stopped the bead. Of course I STILL had to wipe across the seams to remove the residual, but it was a lot less work, mess and waste than the standard float method as none had dried on the tile face...
I bought this because of the allure of not having to seal the grout. But compared to the difficulty I had in applying this stuff, sealing standard grout doesn't seem so bad. I have another one for the floor that I'm gonna return. But after reading this, some may decide they would not have a problem with it. I've never tried epoxy grout, but I can't imagine it being easier. Hope this helps.
September 30, 2016
Rated 5.0 out of 5.0 by MEinNE great all in one grout
A bit pricey, but the ease of use makes up for it for this DIY'er. It's has sealant in the pre-mix so no follow-up steps. Love it.
August 23, 2016
Rated 3.0 out of 5.0 by RZR1 Check cure time! Tub says 3 days, but website says 7 days.
Please check the cure time on this grout!! The tub says three days, but Custom's website says 7 days. I called technical support and confirmed that the cure time is indeed 7 days. Clearly Custom Buildiing Products has a problem on their hands. How can a product be expected to perform in the manner which is expected with conflicting cure times? Here is the cure time from the website.
Once grouting of walls is completed,
remove the towels and dry off the tile
and grout joints.
The floor assembly must be dry for
24 hours before grouting.
After grouting, allow the entire tile
assembly to cure for seven (7) days
before running water in the shower.
April 28, 2016