Rated 3.1 out of 5 by 29
Rated 4.0 out of 5.0 by Mark good perchase
good spout light weight easy to install and Erin D was very helpful
April 29, 2015
Rated 4.0 out of 5.0 by scmead Just what was needed
Tub spout was nicely made and came with all the necessary hardware. The only tricky part is getting the set screw to lineup properly while putting the spout in place. Once that was done it worked just fine.
February 26, 2015
Rated 4.0 out of 5.0 by D1981 Great Purchase
The tub spout worked like it was designed to. The only issue was with the included plumbers tape I highly recommend you use your own plumbers tape. The one included leaks a lot. Even with that I am satisfied with the purchase.
January 30, 2015
Rated 3.0 out of 5.0 by scuba1 Too many applications
My positive answer to recommending the product should have been a maybe. Cheap, but then I guess that is expected for the price. As a contractor for over 40 years I have installed many of this type diverters and this one gave me the most problem; it took 3 tries. It will install in most applications but I would not buy one fro my own house.
January 14, 2015
Rated 1.0 out of 5.0 by Flapjackjones ABSOLUTE JUNK!
Don't waste your money and especially your time on this. I have a pretty solid background in mechanics.Machine shop,automotive and appliance repair. The print is very small on the "instructions"and it mentions "screw G" There is no screw G. Also like somebody previously mentioned there is no hole drilled for screw "E" to go thru to tighten on the "Stub Out Nipple". Also I don't see how you can possible tighten the "slide adapter" and be able to see if the slot is lined up for the screw to go thru.I gave up and returned it. Don't waste your time and money you will only get aggravated.
July 9, 2013
Rated 1.0 out of 5.0 by Camman475 These Do Not Work!
I purchased two of these for my house. After fighting for hours to get them to fit and nearly destroying one of my bathrooms I called a plumber. He immediately asked if I bought them at HomeDepot I said yes and he informed me that even he is not able to get the HomeDepot spouts to fit. He then brought in one of his higher end spout by ProFlo and it slid on without any fuss. took him 5 seconds to have it on and ready. He told me to return mine and then told me where I can buy the better spouts so I don't have to pay him $100's to install them. Buyer Beware, spend the extra $20 or $30!!! It will save you in the long run!!
November 20, 2011
Rated 2.0 out of 5.0 by Raul Could not make it work...
Really bad installation instructions. The whole "slip-on system" relies on a rubber gasket to stop water back flow. Well, that's fine in a perfect world; maybe where the copper nipple coming out of the wall is not only perfectly smooth and clean, but also at its factory spec OD. The latter can hardly be achieved, particularly after a few removals, re-cleaning, re-sanding, etc. due to leakages... I could never make it stop leaking to the back. In the end, I had to resort to soldering copper pieces (exactly what I wanted to avoid!) to return it back to a "screw-on system."
November 11, 2014
Rated 1.0 out of 5.0 by doc21 REALLY Bad purchase
Difficult to install and get to be flush with wall. Once installed, leaked so badly back into spout and into wall opening, that it caused water damage to the ceiling beneath. Ordered an American Standard version & it installed flawlessly in under a minute - no leaks.
October 30, 2014