Rated 4.2 out of 5 by 59
Rated 2.0 out of 5.0 by steve Bit bent trying to drill steel angle iron
Tried using the 5/32 and 9/64 to drill through some soft 1" angle iron. Both bits bent. did not break, but they bent to 60 deg angle. not much good after that. finally drilled hole with self taping screw......
March 19, 2014
Rated 5.0 out of 5.0 by DIYer dewalt quality
After many failed attempts to do simple tasks with Ryobi drill bits, i decided to try Dewalt on recommendation from a contractor friend. I can say honestly i will only be using Dewalt bits from now on. Unlike other "titanium" bits, these can actually drill through metal with relative ease ad without breaking. Also, the drill bit shaft has a non-circular profile to allow better transfer of torque from the drill to the bit. Definitely a great buy.
January 16, 2013
Rated 1.0 out of 5.0 by WildMan Worst set of bits I've ever bought from Home Depot!
Lousy bits, will NOT DRILL METAL WORTH A DARN, have used this kind before, this batch was VERY DISAPPOINTING, VERY UPSET BET WHAT DO YOU DO.
September 15, 2015
Rated 4.0 out of 5.0 by HomeUser01 I own 3 or 4 of these
I use these for Wood/brass/nickel-silver and aluminum
Some steel as well. I do not have any problems with these bits.
I usually wind up shorting the bits for my application in small (limited) spaces.
for replacements, The price of an individual bit that matches the set is too high compared to buying the entire set.
I would love to have individual of 3/8s if the bit wasn't nearly half the price of the entire set.
which could replace older or missing bits from sets.
I go through 1/8 bits as well, but I buy them by the 2 pack, which isn't as bad as the 3/8
The pilot which drills deeper than the rest of the bit is nice for starting, but a lot of my applications don't require this. I think a smaller pilot tip would work just as well. Overall it's the one I buy.
March 12, 2015
Rated 5.0 out of 5.0 by JeremyK Excellent set of bits
I bought this for drilling aluminum. They work great, and go through the metal quickly and with much less heat generated than my other drill bit set. I haven't put much pressure on them, but they appear very sturdy. The tips work great to start a hole and I don't need to use a punch to mark holes in most cases.
October 22, 2013
Rated 5.0 out of 5.0 by Bill Great product
Excellent buy. Wood and tin use is great . having the 1/2 drive ability is useful
July 14, 2015
Rated 5.0 out of 5.0 by none Pin point accuracy
My project required the accuracy of drilling four 1/4" holes in the quarter panel of an antique car without any paint chips or any two of the holes being off center to each other. The project was finished without a flaw!
June 23, 2015
Rated 5.0 out of 5.0 by Hammer Good drill bit set
Very satisfied with the set. Had to drill through 1/4 " & 1/2" steel and the bits proved their worth.
March 5, 2013