Rated 2.1 out of 5 by 46
Rated 1.0 out of 5.0 by mkd545 Don't Like
These seem to me to be very cheaply made and the adjustment knob on these at times is very difficult to turn. Direct sun on this worries me due to the type of plastic this is made of. I much prefer hard plastic manifolds.
July 19, 2016
Rated 1.0 out of 5.0 by Mitch Valves pop out of head
Six 1/4" valves blow out of manifold when the water is turned on. I have a pressure reducer and that line is running at 25 PSI. The valves pop right out of the head when the water is turned on. I'm going to try gluing the valves into the head. Seems like the factory should be gluing them in. Pretty cheap price, but will be okay if gluing works.
June 28, 2016
Rated 1.0 out of 5.0 by Longlegs Junk
They blow out of the manifold and I'm at 15 psi! Don't waste your time.
June 9, 2016
Rated 1.0 out of 5.0 by dick Unreliable
I bought 6 of these and 3 have failed, the other 3 have unreliable flow rates
May 11, 2016
Rated 1.0 out of 5.0 by Bothangbi Unreliable
Manifold is unreliable at best. Drip outlet works intermittently. Adjustable knobs are difficult to turn, often slipping. I was so frustrate with it and decided to throw it away and use something else. Don't waste your money and TIME on this one.
April 25, 2016
Rated 4.0 out of 5.0 by robert good one
You need to bury it so that the sunlight will not reach it and it will last for more than two years.
May 10, 2016
Rated 4.0 out of 5.0 by Rowboat Product works fine
I had no leaks when I finished. I had some difficulty attaching the drip tubes on the bottom outlets. I would use a longer extension next time. I have used other products, but they end up leaking out the top. This one had no leaks, and this product is adjustable on each line.
April 3, 2016
Rated 3.0 out of 5.0 by macbuz Hose connection to nipples
After reading these reviews I see many people struggling with the 1/4" hose connections and consequently putting too much force on the valves.
My suggestion is simple. I own a heat gun, you probably have access to a hair drier or other such tool. Just heat the hose end till it's a little more malleable and it should slip right on.
*Note - I don't own one of these but my experience tells me that this idea should help. Also, any ratings I gave to quality/value/etc are meaningless as I don't own one to rate. Just offering an idea.
January 17, 2016