Rated 4.7 out of 5Â by 195
Rated 5 out of 5Â by builder52 excellent blades even sharp after cutting NAILS
These blades are excellent and LONG LASTING even after cutting NAILS in remodels
May 20, 2014
Rated 5 out of 5Â by DstBstSN Lesson Learned
I'm replacing all of the interior doors in my house and wanted to get a nicer blade for the ol' circular saw. I stood in HD looking at the blades and while the option to save some cash on a cheaper blade was appealing, I've been very happy with previous Diablo blades. Glad I made that choice, this blade has left clean edges and shows no signs of dulling. You get what you pay for!
July 19, 2013
Rated 4 out of 5Â by Karl Diablo 60 tooth carbide circular saw blade
The 60 tooth Diablo blade is used primarily for cutting higher grade plywood with my circular saw vs. combination blade for dimension lumber cuts. Clean cut, low noise factor and economical blade for my shop projects.
September 2, 2014
Rated 5 out of 5Â by DOLT Great for cutting laminate flooring
I just finished installing some PERGO laminate flooring (about 200 sq. ft.) in a bedroom. Except for the few occasions where I needed to use the jigsaw, I used one of these blades in my circular saw for every cut during the installation. I can tell you that it performed flawlessly. It cut like a hot knife through butter, and it made very clean cuts with no chipping or other problems (I cut the planks with the good side down).
Since my flooring installation was a small job, I can't say too much on durability or longevity, but the cuts at the end of the job were just as good as the cuts when the blade was new.
December 11, 2010
Rated 5 out of 5Â by csep Smooth cutitng carbide blade
I needed a circular saw blade to cut furniture grade hardwood plywood without tearing up the grain.
I found this blade at Home Depot. The price is good and it works great.
Tip, before making a cut, score the wood with a sharp box cutter knife using a straight edge. Then saw just slightly beyond the score line. This helps prevent splintering.
September 17, 2013