Rated 4.4 out of 5 by 14
Rated 5.0 out of 5.0 by RedFiftySix Just what I needed
Being someone that uses my Dremel almost daily, I know that I can come to HD and get exactly what I need. I've even started to build up an inventory because the prices are reasonable.
Thanks for being a constant 'go to' for me!
June 28, 2016
Rated 1.0 out of 5.0 by ron poor choice
Sales person said this would fit my dremal 3000.....NOT
July 12, 2016
Rated 5.0 out of 5.0 by Johm No better cut-off wheels
I have a diamond cut-off wheel, but the diamond coating wears away with use. I still need these disposable cut-off wheels to replace worn ones.
May 3, 2016
Rated 5.0 out of 5.0 by Laus150 Excellent cut-off wheels
I have used these cut-offs wheels for years and they do a great job in cutting metals and plastics.
March 8, 2016
Rated 4.0 out of 5.0 by Richierich03 Very good performance!
Used this wheel to cut through pvc pipe. Had to make teeth on 3" pvc for well point installation. Cut through well, although a few of the wheels did fail and break apart overall did a very good job! Would buy again!
February 9, 2016
Rated 4.0 out of 5.0 by 2342325 Did what I needed
It does work well, but it does wear down fast and they are very fragile if they are bumped
December 23, 2015
Rated 5.0 out of 5.0 by Gramps Tough Enough and Highly Recommended.
I secure my dremel tool in a special 3/8" mount on my mini-lathe to cut slots for screws and to shape other small parts for old .22 cal rifles and pistols. These cut-off wheels are strong enough to make aggressive passes on cold-rolled steel rods without losing their original squared-off edge, leaving smooth, mill-like slots and surfaces. For now, I can put off the expense of a mini-milling machine. This pack of 20 wheels will last me for a very long time.
December 8, 2015
Rated 5.0 out of 5.0 by alice cuts metal cleanly
I like these better than the Dremel snap-on metal cutting disks. These don't make as many sparks. I used these to trim down a tub spout and the corners of a stainless sink (it was going in a tight spot). You can get a clean line if you go slow and carefully. These disks wear down and will break if you twist them when cutting. However, you get a lot of them so they are a good value.
October 23, 2012