Rated 3.2 out of 5 by 32
Rated 5.0 out of 5.0 by Angel worked great.
worked on the Dremel perfectly and made accurate clean cuts on tiles and fiberglass.
June 21, 2016
Rated 2.0 out of 5.0 by LesK Limited Abilities
The bit cut travertine well but was useless on ceramic tile. Don't even try it.
June 9, 2016
Rated 5.0 out of 5.0 by Jose Clay tile
It worked great in clay tile for several aplications and it still works
February 10, 2016
Rated 3.0 out of 5.0 by AaronL Not for floor tile
Floor tile: worthless
Wall tile: okay
The bit is okay for thin wall tile. I've used it with decent satisfaction. But it is USELESS for floor tile. It'll make a tiny groove before it glows red and stops cutting.
December 7, 2015
Rated 1.0 out of 5.0 by Ryan Unfortunate
The guy at the store really talked this bit up, bought it and tried it for backsplash and it would not cut at all, just cracked the tiles if it did anything at all. I cannot recommend this product for doing a backsplash.
June 7, 2016
Rated 1.0 out of 5.0 by KenW Dulls very fast
I needed to cut small notches in backsplash tile for wall plate screws. It kind of worked for the first couple, although it was very slow. Then it was obvious the bit was getting dull fast and it wouldn't cut at all.
May 6, 2016
Rated 5.0 out of 5.0 by JMOdiy This tiny thing was a lifesaver!
I thought I'd have to buy some expensive equipment to get my tiles cut out around pipes in the bathroom. This little bit worked amazingly well and lasted through more cuts than I thought it would.
November 3, 2015
Rated 5.0 out of 5.0 by chunkcheezy Does what it's supposed to do
I cut several pieces of ceramic tile for outlets in a kitchen back splash, both before mounting the tile and after mounting. Truthfully, I think it worked better after I had the tile on the wall even though I had my workpieces clamped down. I was doubting this would work for me due to some negative reviews but it was great. Looking forward to using it again. Just go slow and try to keep the bit and your Dremel cool. Used with a Dremel 3000 and the depth attachment (looks like a router type attachment).
June 23, 2015